I?m still struggling to swap PCs to a replacement PDC. Is there a way to reset the machine account (trust relationship) between an existing PC (Windows XP) and a replacement PDC with the same settings as the original PDC? I think it works if I take the PC off the domain by setting it to a workgroup and then put it back onto the domain when connected to the new PDC. However, I?d feel a lot happier if there was another way to do this! Thanks.
Tompkins, Michael
2013-Dec-09 18:46 UTC
[Samba] smbclient 4.1.2 with -m SMB2 gives Bad SMB2 signature for message
When I run a cross-compiled version(for ppc) of smbclient with -m SMB2 parameter, I get: Bad SMB2 signature for message [0000] E1 90 A0 C5 31 A8 26 31 10 D8 96 CF 68 14 E9 97 ....1.&1 ....h... [0000] CA EF F3 A8 AA C7 4D C1 05 34 39 F1 B4 7E 79 43 ......M. .49..~yC session setup failed: NT_STATUS_ACCESS_DENIED If I run it without the -m SMB2 parameter, everything works fine. If I run a version of 4.1.0 from my linux box(not cross-compiled) and the 4.1.2 version on my ppc platform, with the same parameters, they both look the same with the first 7 packets, in WireShark. Then the 4.1.2 version, just quits with the above message. Any help or direction is greatly appreciated. - Mike
Tompkins, Michael
2013-Dec-10 20:47 UTC
[Samba] smbclient 4.1.2 with -m SMB2 gives Bad SMB2 signature for message
In addition to this question, I noticed there are 2 versions: smbclient and
smbclient4. For 4.x, should we use the smbclient4. When I run this, my output is
different:
dos charset 'CP850' unavailable - using ASCII
Connection to \\13.121.10.166\ScanRepo failed - NT_STATUS_REVISION_MISMATCH
Regards,
- Mike
?
?
-----Original Message-----
From: Tompkins, Michael
Sent: Monday, December 09, 2013 1:46 PM
To: samba at lists.samba.org
Cc: USA Xerox Samba
Subject: smbclient 4.1.2 with -m SMB2 gives Bad SMB2 signature for message
When I run a cross-compiled version(for ppc) of smbclient with -m SMB2
parameter, I get:
Bad SMB2 signature for message
[0000] E1 90 A0 C5 31 A8 26 31 10 D8 96 CF 68 14 E9 97 ....1.&1 ....h...
[0000] CA EF F3 A8 AA C7 4D C1 05 34 39 F1 B4 7E 79 43 ......M. .49..~yC
session setup failed: NT_STATUS_ACCESS_DENIED
If I run it without the -m SMB2 parameter, everything works fine. If I run a
version of 4.1.0 from my linux box(not cross-compiled) and the 4.1.2 version on
my ppc platform, with the same parameters, they both look the same with the
first 7 packets, in WireShark. Then the 4.1.2 version, just quits with the above
message. Any help or direction is greatly appreciated.
- Mike