Hi Peter,
If the install worked fine, then you should be able to run the daemon with:
/usr/local/samba/smbd -- -D
You probably can't call it without the full path because
/usr/local/samba/is not in your path.
If you want to remove a program compiled from source, go back to the source
directory and run
make uninstallbin
make uninstalldat
make uninstallman
make uninstallmo
make uninstallmsg
make uninstallscripts
make uninstall
Tell me if this helps
---
*Santiago DIEZ
Directeur
*+33 6 37 90 81 98
+33 9 70 44 77 87
2011/2/27 Herczeg P?ter <h.pjotr at gmail.com>
> Hi Santiago,
>
> I have tried the follow the HowTo precisely, so I have installed it to: *
> /usr/local/samba*
> By following the instructions (and wanted to run in standard mode) I have
> just typed "samba".
> tried smbd, samba4, but no success.
>
> I did the whole downloading/compiling/installing/provisioning process as
> 'root', I think it has full access for the partition.
>
> To make a very clean install how can I remove everything related to samba3
> or samba4? (during initial setup of Debian installation I have selected
> Samba to install as a feautre)
> I tried to remove with apt-get autoremove, but I got the error message that
> samba4 virtual package cannot be removed.
>
> since then, after I reinstalled samba4 followed the HowTo, the samba-master
> directory does not appear in my home folder (it was there, when I
previously
> installed)
>
> If I send you the summary files or process information related to
> compiling/installing/provisioning can help you?
>
> Thanks for your time,
>
> Peter
> 2011. febru?r 27. 11:04 Santiago DIEZ ?rta, <
> santiago.diez at quark-systems.com>:
>
> Hi Peter,
>>
>> What directory have you installed the binaries to?
>> Are you running the samba command with full path?
>> What command exactly?
>> Have you checked execution privilege on the partition?
>>
>> Bye
>> ---
>> *Santiago DIEZ
>> Directeur
>> *+33 6 37 90 81 98
>> +33 9 70 44 77 87
>>
>>
>>
>>
>> 2011/2/27 Herczeg P?ter <h.pjotr at gmail.com>
>>
>>> Dear All,
>>>
>>> I would like to ask your help:
>>>
>>> I have installed Samba4 by following the steps of Samba4 Wiki Howto
to a
>>> Debian Server.
>>>
>>> - downloaded via git
>>> - compiled successfully
>>> - make quicktest is ok. (as far as I see during the process, it has
>>> written
>>> at the ned: ALL OK)
>>> - install is successful ('install' finished successfully)
>>> - DC provision is successful (get the summary windows at the end,
only
>>> notice is to configure phpLDAPadmin)
>>>
>>> And the problem is:
>>>
>>> going to the next step, I try to start&test, but I get the
error message
>>> when executing samba command:
>>> "command not found"
>>>
>>> tried to start as service but no success.
>>> if I used the install path in the same way as it written in the
HowTo,
>>> how
>>> can I check is it running and is able to manage the domain?
>>>
>>> Thanks in advance,
>>>
>>> Peter
>>> --
>>> To unsubscribe from this list go to the following URL and read the
>>> instructions: https://lists.samba.org/mailman/options/samba
>>>
>>
>>
>
>
> --
> Herczeg P?ter
>