Nut upsuser - May 2015 - Are UPS shutdown commands automatically sent?

Roger,

Your guide is already my go-to source, especially since openSUSE 13.1 is our
currently supported system (though I'm doing this testing on Porteus due to
its file system resilience).  It's AWESOME, btw.  Very helpful.

I'll spend some time tomorrow going through chapter 6 and trying again.

Sincerely,
Robert G. Groner
Software Engineer

RTD Embedded Technologies, Inc.
ISO 9001 and AS9100 Certified
Ph: 814-234-8087
www.rtd.com

-----Original Message-----
From: Roger Price [mailto:roger at rogerprice.org] 
Sent: Thursday, May 21, 2015 3:59 PM
To: Rob Groner
Subject: Re: [Nut-upsuser] Are UPS shutdown commands automatically sent?

On Thu, 21 May 2015, Rob Groner wrote:
> I?m testing that my system will shutdown when the UPS has been on 
> battery for 10 seconds.? That all works fine?.10 seconds after pulling 
> the plug, my system does shut down.? However, I am not getting the 
> commands into the UPS telling it to power off and then power on.? I had
thought I read somewhere that these commands are sent automatically when ?upsmon
?c fsd? happens?but I can?t find that, nor can I find any clear instructions on
where I would put the commands to tell the UPS to start its shutdown and restart
timers.
Hi, I went through the same learning curve.  I wrote up my notes at
http://rogerprice.org/NUT.html Perhaps there is something there that could help
you.  Best Regards, Roger