Nut upsuser - Dec 2010 - (no subject)

I am have a nice result whith blazer_ser driver! respect!

# ./nut start
Network UPS Tools - UPS driver controller 2.4.1
Network UPS Tools - Megatec/Q1 protocol serial driver 1.51 (2.4.1)
Supported UPS detected with megatec protocol
Vendor information read in 1 tries
Battery runtime will not be calculated (runtimecal not set) 
<================= !!!
Starting nut.
Network UPS Tools upsd 2.4.1
listening on 172.16.0.220 port 3493
listening on 127.0.0.1 port 3493
Connected to UPS [Powercom]: blazer_ser-Powercom

backup# upsc Powercom at localhost
battery.voltage: 28.80 <========= !!! it is a normal? what u thing about 
this value??  iam have 4x7AH battery in Ups
battery.voltage.nominal: 24.0
beeper.status: disabled
driver.name: blazer_ser
driver.parameter.pollinterval: 2
driver.parameter.port: /dev/cuau0
driver.version: 2.4.1
driver.version.internal: 1.51
input.current.nominal: 5.0
input.frequency: 50.0
input.frequency.nominal: 50
input.voltage: 237.0
input.voltage.fault: 237.0
input.voltage.nominal: 220
output.voltage: 237.0
ups.delay.shutdown: 30
ups.delay.start: 180
ups.firmware: LCD  V2.1
ups.load: 74
ups.mfg: POWERCOM
ups.model: RXL-1000
ups.status: OL
ups.temperature: 0.0
ups.type: online

Broadcast Message from *******************
        (no tty) at 22:42 EET...

Communications with UPS Powercom at localhost established

im come back after learning you Tools!! thx!

Citeren ahouse-support <support op ahouse.mine.nu>:
> # ./nut start
> Network UPS Tools - UPS driver controller 2.4.1
> Network UPS Tools - Megatec/Q1 protocol serial driver 1.51 (2.4.1)
> Supported UPS detected with megatec protocol
> Vendor information read in 1 tries
> Battery runtime will not be calculated (runtimecal not set)  
> <================= !!!
RTFM - 'man 8 blazer'.
> backup# upsc Powercom op localhost
> battery.voltage: 28.80 <========= !!! it is a normal? what u thing  
> about this value??  iam have 4x7AH battery in Ups
This boils down to about 2.4 V / cell, which is fairly high for a PbAc  
battery. But please understand that a UPS is not a measuring  
instrument. More often than not, the reported resolution is much more  
than the accuracy of the measurement justifies. So unless your  
batteries wear out quickly, you can safely ignore this.

Best regards, Arjen
-- 
Please keep list traffic on the list (off-list replies will be rejected)