On 12/8/05, Eric S. Johansson <esj@harvee.org>
wrote:> I'm trying to set up a belkin f6c1100-unv UPS to work with nuts. From
> reading the mailing list, it sounds like the belkinunv serial driver
> should work and that the USB driver is potentially troublesome. Is this
> a correct impression?
I believe that is correct... unless you run the CVS version of the
code. I believe there have been recent additions that have cleaned up
these problems. I have an F6C1100-UNV working over serial right now.
> Also I may have missed this but if I do go with the serial (or USB port)
> is there any simple command line method for verifying basic
> connectivity? The only reason I ask is I have gone around the drain to
> many times trying to figure out apparent system configuration problems
> when it was really a device configuration problem (i.e. serial cable
> plugged into the wrong port on the back of the PC. :-)
Check: http://www.networkupstools.org/doc/2.0.1/INSTALL.html
Section 8, 11, and 12 should be helpful for that kinda stuff.
> many thanks
>
> ---eric
>
> _______________________________________________
> Nut-upsuser mailing list
> Nut-upsuser@lists.alioth.debian.org
> http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
>
--
----------------------------------------------------------
Are Your Friends Lemmings?
-- http://www.lemmingshirts.com