Deletion does not remove all, Try a erase if that did not work. Configuration files are not always where you expect then to be. Regards Michael Cole On Friday, September 30, 2016 9:16:44 PM TE Dukes wrote:> I deleted all virtualization packages and re-installed. > > Something must have been hosed up. > > Installing a VM and it didn't even ask to setup the network. Hopefully > that's a good sign. > > Will know shortly.................... > > TIA > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos
> -----Original Message----- > From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On > Behalf Of Michael Cole > Sent: Friday, September 30, 2016 9:41 PM > To: centos at centos.org > Subject: Re: [CentOS] Virtualization Networking > > Deletion does not remove all, Try a erase if that did not work. > > Configuration files are not always where you expect then to be. > > Regards Michael Cole > > On Friday, September 30, 2016 9:16:44 PM TE Dukes wrote: > > I deleted all virtualization packages and re-installed. > > > > Something must have been hosed up. > > > > Installing a VM and it didn't even ask to setup the network. Hopefully > > that's a good sign. > > > > Will know shortly.................... > > > > TIAOK, I'm about done trying to get this to work. I have spent HOURS reading, installing, re-installing, etc. I can get the guest to access the internet but have tried every was possible to be able to access the guest from the LAN or even the host. Nothing I have tried works. The only thing all documentation leaves out is how to set up the guest networking during the install. Seems if I don't set anything up or just set it to DHCP it has internet connectivity, but that is all. I have gone back in after the guest has been installed and changed the networking configuration to match my LAN, that doesn't work either. I lose internet accessibility when I do that. I have tried to install CentOS 7 and Debian 8, the same problems with each. I have tried CentOS the built in Virt-Manager and VirtualBox. with same results. Can't seem to find the free version of VMware but I suspect I would have the same results as well. Again, any help would be greatly appreciated. TI!
On Mon, Oct 3, 2016 at 1:54 PM, TE Dukes <tdukes at palmettoshopper.com> wrote:> > > > -----Original Message----- > > From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On > > Behalf Of Michael Cole > > Sent: Friday, September 30, 2016 9:41 PM > > To: centos at centos.org > > Subject: Re: [CentOS] Virtualization Networking > > > > Deletion does not remove all, Try a erase if that did not work. > > > > Configuration files are not always where you expect then to be. > > > > Regards Michael Cole > > > > On Friday, September 30, 2016 9:16:44 PM TE Dukes wrote: > > > I deleted all virtualization packages and re-installed. > > > > > > Something must have been hosed up. > > > > > > Installing a VM and it didn't even ask to setup the network. Hopefully > > > that's a good sign. > > > > > > Will know shortly.................... > > > > > > TIA > > > OK, I'm about done trying to get this to work. I have spent HOURS reading, > installing, re-installing, etc. > > I can get the guest to access the internet but have tried every was > possible > to be able to access the guest from the LAN or even the host. Nothing I > have > tried works. > > The only thing all documentation leaves out is how to set up the guest > networking during the install. Seems if I don't set anything up or just set > it to DHCP it has internet connectivity, but that is all. > > I have gone back in after the guest has been installed and changed the > networking configuration to match my LAN, that doesn't work either. I lose > internet accessibility when I do that. > > I have tried to install CentOS 7 and Debian 8, the same problems with each. > I have tried CentOS the built in Virt-Manager and VirtualBox. with same > results. Can't seem to find the free version of VMware but I suspect I > would have the same results as well. > > Again, any help would be greatly appreciated. > > TI! > > >If you still have in place environment with virt-manager, can you send the output of virsh net-list Then for every network-name you get into the output of the command above in column "Name" virsh net-dumpxml network-name Then brctl show Feel free to transform any ip you think could be sensible. Gianluca
On 2016-10-03, TE Dukes <tdukes at palmettoshopper.com> wrote:> > >> -----Original Message----- From: >> centos-bounces at centos.org >> [mailto:centos-bounces at centos.org] On >> Behalf Of Michael Cole Sent: Friday, September 30, 2016 9:41 PM To: >> centos at centos.org Subject: Re: [CentOS] >> Virtualization Networking >> >> Deletion does not remove all, Try a erase if that did not work. >> >> Configuration files are not always where you expect then to be. >> >> Regards Michael Cole >> >> On Friday, September 30, 2016 9:16:44 PM TE Dukes wrote: >> > I deleted all virtualization packages and re-installed. >> > >> > Something must have been hosed up. >> > >> > Installing a VM and it didn't even ask to setup the network. >> > Hopefully that's a good sign. >> > >> > Will know shortly.................... >> > >> > TIA > > > OK, I'm about done trying to get this to work. I have spent HOURS > reading, installing, re-installing, etc. > > I can get the guest to access the internet but have tried every was > possible to be able to access the guest from the LAN or even the host. > Nothing I have tried works. > > The only thing all documentation leaves out is how to set up the guest > networking during the install. Seems if I don't set anything up or > just set it to DHCP it has internet connectivity, but that is all. > > I have gone back in after the guest has been installed and changed the > networking configuration to match my LAN, that doesn't work either. I > lose internet accessibility when I do that. > > I have tried to install CentOS 7 and Debian 8, the same problems with > each. I have tried CentOS the built in Virt-Manager and VirtualBox. > with same results. Can't seem to find the free version of VMware but > I suspect I would have the same results as well. > > Again, any help would be greatly appreciated. > > TI!VirtualBox gives you a GUI for setting up port forwarding from the host to the guest. It's under Machine -> Settings -> Network -> Advanced. Did you try it? -- Liam
On Mon, Oct 03, 2016 at 07:54:36AM -0400, TE Dukes wrote:> > OK, I'm about done trying to get this to work. I have spent HOURS reading, > installing, re-installing, etc. > > I can get the guest to access the internet but have tried every was possible > to be able to access the guest from the LAN or even the host. Nothing I have > tried works. > > The only thing all documentation leaves out is how to set up the guest > networking during the install. Seems if I don't set anything up or just set > it to DHCP it has internet connectivity, but that is all. > > I have gone back in after the guest has been installed and changed the > networking configuration to match my LAN, that doesn't work either. I lose > internet accessibility when I do that. > > I have tried to install CentOS 7 and Debian 8, the same problems with each. > I have tried CentOS the built in Virt-Manager and VirtualBox. with same > results. Can't seem to find the free version of VMware but I suspect I > would have the same results as well. > > Again, any help would be greatly appreciated.Don't know about the other VM software, but I have several VM guests under VirtualBox. Each of them has their networking set up as "bridged adapter". Although they could use DHCP then, I've used each virtual guest's network software to set them up with static address configs. No problems reaching other lan hosts in either direction nor in reaching the internet. Jon -- Jon H. LaBadie jon at jgcomp.com 11226 South Shore Rd. (703) 787-0688 (H) Reston, VA 20190 (703) 935-6720 (C)
On 10/03/2016 04:54 AM, TE Dukes wrote:> I can get the guest to access the internet but have tried every was possible > to be able to access the guest from the LAN or even the host. Nothing I have > tried works. > > The only thing all documentation leaves out is how to set up the guest > networking during the install."All documentation" doesn't leave out this information. The links I sent earlier clearly and specifically document the process for setting up a network bridge, which you need to do if you want to access your VM from the LAN. If you need help, you need to provide more information than "I can't get this to work" and "I've tried everything." Those don't tell us anything about the state of your system. Useful information would include: your configuration files (/etc/sysconfig/network-scripts/ifcfg-*), the output of "ip link show" and "ip addr show", the output of "brctl show", and maybe the output of "virsh iface-list".