> -----Original Message-----
> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On
> Behalf Of Richard
> Sent: Friday, September 30, 2016 8:50 AM
> To: CentOS mailing list
> Subject: Re: [CentOS] Virtualization Networking
>
>
>
> > Date: Friday, September 30, 2016 07:14:59 -0400
> > From: TE Dukes <tdukes at palmettoshopper.com>
>
> >> From: Gordon Messmer
> >> Sent: Friday, September 30, 2016 1:01 AM
> >>
> >> On 09/29/2016 07:54 PM, TE Dukes wrote:
> >> > For whatever reason, the default NAT setup no longer works.
> >>
> >> Start over with a new install. Record each change you make,
> >> carefully.
> >>
> >> > I got some kind
> >> > of bridge network (mactap) setup that has access to the
outside but
> >> > I still can't connect locally.
> >>
> >>
> >> As I noted, when using the macvtap, the host and guest can't
> >> communicate unless you enable hairpin mode.
> >>
> >
> > I read something about turning off and disabling NetworkManager. I
> > haven't done this.
> >
> > I'm getting ready to throw in the towel. If I can't set this
up to at
> > least access the VM from the LAN, I can't test CentOS 7 and the
> > software I want to run. It makes it very hard to setup and configure
> > with vi.
> >
>
> I found this guide from Dell to be easy to follow in getting things set up
> quickly. Once you have it working you can tweak things, but this might
help> you get past your initial hurdles.
>
>
> KVM Virtualization in RHEL 6 Made Easy
>
> <https://linux.dell.com/files/whitepapers/KVM_Virtualization_in_RHEL_6_
> made_easy.pdf>
>
Thanks!! I appreciate the help!!