CentOS - Dec 2005 - RE: Intel Corporation 82573V Gigabit Ethernet Controller

> 
> Attempting to install CentOS on a new MSI MB (MS 9618), which 
> uses the subject controllers.
> There are two controllers on the board, seems as though only 
> one can be used.
> I have to manually init, using ifconfig eth0, to use it.
> 
> I understand that the Ethernet controller drivers are not available.
> Is there any news on this or a possible date when drivers 
> will be incorporated into the install.
> 
> lspci reads;
> 03:00.0 Ethernet controller: Intel Corporation 82573V Gigabit 
> Ethernet Controller (Copper) (rev 03)
> 04:00.0 Ethernet controller: Intel Corporation 82573V Gigabit 
> Ethernet Controller (Copper)
> 
> I find that on bootup the Intel boot loader indicates that
> The Ethernet port is corrupted or not initalized, now I assume that 
> the boot loader is in the ROM, as it comes up early in the 
> boot process.
> 
> Dmesg says;
> ======================================================> Intel(R)
PRO/1000 Network Driver - version 6.0.54-k2-NAPI
> Copyright (c) 1999-2004 Intel Corporation.
> ACPI: PCI interrupt 0000:03:00.0[A] -> GSI 10 (level, low) -> IRQ 10
> PCI: Setting latency timer of device 0000:03:00.0 to 64
> divert: allocating divert_blk for eth0
> e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection
> ACPI: PCI interrupt 0000:04:00.0[A] -> GSI 11 (level, low) -> IRQ 11
> PCI: Setting latency timer of device 0000:04:00.0 to 64
> e1000: 0000:04:00.0: e1000_probe: The EEPROM Checksum Is Not Valid
> e1000: probe of 0000:04:00.0 failed with error -5

Hello all,

Looking for a how-to on mod_asp and CentOS 4.2 Apache 2.0.52 ? .. 

Need to run some basic ASP pages with CentOS 4.2

BRW