I've been reading the Google searches trying to understand how to tie together Adit 600 to Asterisk to provide 2 way service. I'm about blind from reading. I assume, the answer is using MGCP between the boxes. However, the examples I found don't really explain fully enough to know how to modify examples to work for me. I'll have in the ADIT with T1's. There is a CMG and FXS card installed - later I'd like to add a FXO card. The goal would be able to route calls to and from ADIT from the T1's to Asterisk and route some Asterisk extensions to the FXS card. If you have done this, would you mind posting or sending me your mgcp.conf with some remarks explaining how & why and a your CMG config? Thanks for the time Bart
Bart Fisher wrote:> I assume, the answer is using MGCP between the boxes. However, the > examples > I found don't really explain fully enough to know how to modify > examples to work for me. >Adit 600 TDM to a Digium T1 card> > The goal would be able to route calls to and from ADIT from the T1's > to Asterisk and route some > Asterisk extensions to the FXS card. >I'll be looking to do this as well in a couple weeks. I'll be getting a PRI from a local provider and am guessing that I'll need a 2nd T1 to handle that and use the 1st T1 to handle the Adit. I need to supply some analog lines to the facility. But currently, I have all analog lines going to the punch down hooked into the Adit, from there a T1 cross over cable from the Adit to the PRI card in the Asterisk system. 2 FXO and 2 FXS cards. Around 5 analog phones hanging off the FXS. There is a section on the Wiki on the Adit: http://www.voip-info.org/wiki/index.php?page=Asterisk%20hardware%20channel%20bank%20check -- Ben Franklin quote: "Those who would give up Essential Liberty to purchase a little Temporary Safety, deserve neither Liberty nor Safety."
The Adit is realy simple as all it is is a bridge, so you have one interface that is virtualy cross connected to another interface within the Adit. If you want to use the Adit with asterisk you can put the cards into the Adit (usualy FXS and/or FXO cards) and then connect the Adit to Asterisk, in most cases the Adit is connected to Asterisk using a T1 cable that is connected to a T1 card (like from Digium), however you can also use the CMG card from the Adit, but keep in mind that the CMG card only works with FXS cards and not with FXO. On 6/3/06, Bart Fisher <bhfisher@icpage.com> wrote:> I've been reading the Google searches trying to understand how to tie > together Adit 600 to Asterisk to provide 2 way service. I'm about blind > from reading. > > I assume, the answer is using MGCP between the boxes. However, the examples > I found don't really explain fully enough to know how to modify examples to > work for me. > > I'll have in the ADIT with T1's. There is a CMG and FXS card installed - > later I'd like to add a FXO card. > > The goal would be able to route calls to and from ADIT from the T1's to > Asterisk and route some > Asterisk extensions to the FXS card. > > If you have done this, would you mind posting or sending me your mgcp.conf > with some remarks explaining how & why and a your CMG config? > > Thanks for the time > > Bart > > > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users >