asterisk users - Jan 2006 - 2400P Pinouts

Hi,

this is probably a stupid question but can someone point me to where I 
can find the pinouts for the connector at the back of the TDM2400P card 
from Digium.

I am assuming this is some kind of telecomms standard but I need to 
connect to 8 existing analogue lines and therefor need to wire this 
connector to a patch panel or R11 jacks.

Also most of the docs do not mention this card - am I correct in 
assuming that I have to load the wct24xxp kernel module? and which 
channels will it be for two quad fxo modules 1-8 or 13-20?

Tx

Marnus van Niekerk

-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20060120/0f8819f9/attachment.htm

On 1/20/06, Marnus van Niekerk <m@mjvn.net> wrote:
> Hi,
>
> this is probably a stupid question but can someone point me to where I can
> find the pinouts for the connector at the back of the TDM2400P card from
> Digium.
>
> I am assuming this is some kind of telecomms standard but I need to connect
> to 8 existing analogue lines and therefor need to wire this connector to a
> patch panel or R11 jacks.
>
> Also most of the docs do not mention this card - am I correct in assuming
> that I have to load the wct24xxp kernel module? and which channels will it
> be for two quad fxo modules 1-8 or 13-20?
>
 There's an adapter on VoIPSupply that has the cable that plugs into
these cards and breaks it out into RJ11 jacks for you. Otherwise, you
can just get a telco cat3 AMP cable and a 66 block.

 Yes, you need to load the wct24xxp module, and if your two modules
are to the right of the card, 17-24 will be the assignment.

 BJ

--
Bird's The Word Technologies, Inc.
http://www.btwtech.com/