Hi,
I have a TDM400P running with only one FXO port running on a VIA
EPIA MS10000 (1Ghz Via Eden). When I run zttest from Zaptel 1.2.1 it
hang and when I interrupt it with Ctrl-C that is the result: ?anyone
have some idea about why isn't working?
Some additional info:
# /usr/src/zaptel/zttest -v
Opened pseudo zap interface, measuring accuracy...
--- Results after 0 passes ---
Best: 0.000000 -- Worst: 100.000000 -- Average: 100.000000
Some info:
# lsmod
Module Size Used by
wctdm 35264 1
zaptel 188804 7 wctdm
binfmt_misc 12040 1
# cat /proc/interrupts
CPU0
0: 705996 XT-PIC timer
1: 8 XT-PIC i8042
2: 0 XT-PIC cascade
5: 0 XT-PIC uhci_hcd:usb4, uhci_hcd:usb5
8: 1 XT-PIC rtc
9: 0 XT-PIC acpi
10: 100 XT-PIC ehci_hcd:usb1
11: 2834 XT-PIC uhci_hcd:usb2, uhci_hcd:usb3, eth0, wctdm
12: 114 XT-PIC i8042
14: 6880 XT-PIC ide0
NMI: 0
LOC: 0
ERR: 0
MIS: 0
# info from dmesg
Zapata Telephony Interface Registered on major 196
ACPI: PCI Interrupt 0000:00:13.0[A] -> Link [LNKA] -> GSI 11 (level,
low) -> IRQ 11
Freshmaker version: 73
Freshmaker passed register test
Module 0: Not installed
Module 1: Not installed
Module 2: Not installed
Module 3: Installed -- AUTO FXO (FCC mode)
Found a Wildcard TDM: Wildcard TDM400P REV I (1 modules)
Registered tone zone 0 (United States / North America)
Registered tone zone 0 (United States / North America)
# lspci -vvv
00:13.0 Communication controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
Subsystem: Unknown device b119:0003
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr-
DEVSEL=medium>TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (250ns min, 32000ns max)
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at ec00 [size=256]
Region 1: Memory at e6402000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=55mA
PME(D0+,D1-,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Best Regards.
Antonio.