asterisk users - Dec 2004 - TDM400 problem

I recently swapped 2 FXO modules on to what had previously been a 4 FXS 
version of the TDM400 board. The FXS ports are recognized - the FXO 
ports don't appear to be recognized (ie modprobe wcfxo and ztcfg both 
say channel 1 isn't there). Has anyone experienced this problem? All 
software is current as of this AM. If the old FXS modules are 
re-installed all works just dandy (other than the fact that I need the 2 
FXO ports)...

Thanks!

As you have a TDM400 you should load wcfxs module ( modprobe wcfxs or
modprobe wctdm for new versions) regardless to modules you have installed on
your board. You should also check the signalling specified in zaptel.conf
according to your modules and the order they are placed on your TDM400.

Best regards
Lamine

----- Original Message -----
From: "Steven P. Donegan" <steve@donegan.org>
To: <asterisk-users@lists.digium.com>
Sent: Monday, December 27, 2004 6:01 PM
Subject: [Asterisk-Users] TDM400 problem

> I recently swapped 2 FXO modules on to what had previously been a 4 FXS
> version of the TDM400 board. The FXS ports are recognized - the FXO
> ports don't appear to be recognized (ie modprobe wcfxo and ztcfg both
> say channel 1 isn't there). Has anyone experienced this problem? All
> software is current as of this AM. If the old FXS modules are
> re-installed all works just dandy (other than the fact that I need the 2
> FXO ports)...
>
> Thanks!
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users@lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>

Has anyone seen this message trying to install an TDM400.. spurious
8259A interrupt: IRQ7

This error happens after I do a modprobe wctdm and then the system
hangs.  I am installing this in an Asus motherboard with a VIA P4M266
chipset.