I have a few Cisco 7905G phones and I having a little trouble configuring them. They are working with Asterisk. I'm able to get the sip image loaded, but I can't get the phones to blind transfer. Does the Cisco 7905G Phone use XML Services? If you are using the 7905G phone, would you post any of your configuration files so I can try and figure out where I'm going wrong? Thanks for your help, Randy --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.802 / Virus Database: 545 - Release Date: 11/26/04
On Mon, 6 Dec 2004 22:45:16 -0800, Randy MacKay <randy@creativesurface.com> wrote:> I have a few Cisco 7905G phones and I having a little trouble configuring > them. They are working with Asterisk. I'm able to get the sip image > loaded, but I can't get the phones to blind transfer. > > Does the Cisco 7905G Phone use XML Services? > > If you are using the 7905G phone, would you post any of your configuration > files so I can try and figure out where I'm going wrong? > > Thanks for your help, > > RandyI use them, they work fine with blind transfer. They don't, however, use XML services. I'll send an email following this one direct to you with my configuration. -Shaun
Yes I'm working with 7905G phones. There's no problem in transfer calls. Here's the regarding entry in my sip.conf: [garage] type=friend username=7905g_1 secret=****** host=dynamic canreinvite=no ; Cisco poops on reinvite sometimes defaultip=1992.168.1.7 callgroup=1 context=ipphone But you should'nt forget to enable call transfer within your dial-statement in extensions.conf: [ipphone] exten => 123,1,Dial({$EXTEN}|20|Tt) Also a problem could be the config on the phone itself. Via the webinterface you can tell the phone to handle the transfer buttons or not. Simply go on the page "Call Preferences" and the last two lines called GUI Show Mask and mor important GUI Set Mask handle those settings. You have to enable Bit 10 (Call Transfer) and 11 (Blind Transfer) and now it will work. XML services won't work for my 7905G's. Each entry in the config files is only marked as "reserved" - may be in future there'll be an usable entry but till now there're no entries enabled. Jens> I have a few Cisco 7905G phones and I having a little trouble configuring > them. They are working with Asterisk. I'm able to get the sip image > loaded, but I can't get the phones to blind transfer. > > Does the Cisco 7905G Phone use XML Services? > > If you are using the 7905G phone, would you post any of your configuration > files so I can try and figure out where I'm going wrong? > > Thanks for your help, > > Randy > --- > Outgoing mail is certified Virus Free. > Checked by AVG anti-virus system (http://www.grisoft.com). > Version: 6.0.802 / Virus Database: 545 - Release Date: 11/26/04 > > _______________________________________________ > Asterisk-Users mailing list > Asterisk-Users@lists.digium.com > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users-- Jens Lentf?hr http://www.jens-it.de