Hi, I'm having an interesting problem with my card. It seems to work fine, for the most part. When I first load the module and asterisk, it detects the line in the on-hook state. However, after the first phone call, zap show channel 1 lists it as being off-hook. During subsequent calls, the card is listed as being on-hook, and when it's not used -- off-hook. There are also some weird problems with detection when the remote side hangs up -- sometimes it works, other times it doesn't. However the times when it doesn't are usually when the other side is a cell-phone. (Does this matter?) Does this off/on-hook reversal stuff matter? Is there any reason that remote disconnect would not work *some* of the time? I checked the line, and the voltage drops when the remote side hangs up (checked with a regular phone with an LED-lit keypad). What settings should I be playing around with? Is it OK if other phone devices are hooked up to the same line if they are never used? Does a phone plugged in actually change any characteristics of the line if it's never picked up? The card is actually a clone card, and though I realise that a lot of people on this list are strongly against the people who use clones, I urge you to consider this question as if it were an actual digium x100p card, and not just write it off as a clone-related problem. Of course, if there are no good explanations, I'm willing to accept that as the cause. Thanks, Ilia Mirkin imirkin@mit.edu