I did everything you specified but couldn't get it to work on 2.4.25.
With tcpdump I could see incoming ICMP, UDP, and TCP packets on each
end, but they would just fall off the end of the earth--no replies at all.
The sethdlc and sethdlc-new programs are in the zaptel directory on CVS.
Depending on your kernel, one of them won't compile.
Somewhere I read that the "new" hdlc in 2.5.x was backported to 2.4.20
or 2.4.21. So I went back to 2.4.19 and hdlc works fine--I have four
channels voice, 19 data, and the dchan on a T-1 crossover cable.
Contact me off list and I'll send the configs.
MW
Michael A Rowley wrote:
> Hello all,
>
> My set up is a fractionated t1, with 1-6 voice channels, 21-24 data
> channels. I have a t100P installed in a amd 1500 with 512meg.
>
> Question:
> In order to set up the data channels, is the following correct?
>
> 1) compile new kernel with generic hdlc support
> 2) compile hdlc from hq.pm.waw.pl/hdlc
> 3) uncomment KFLAGS+=DConfig_ZAPATA_NET in zaptel makefile
> 4) compile zaptel,
> 5 compile rest of asterisk
> 6) add following to zaptel.conf
> span=1,0,0,esf,b8zs
> e&m=1-6
> nethdlc=21-24
> 7) sethdlc hdlc0 hdlc_net
> (I know there is supposed to be a parity and another setting, but
> bugger if I know that they mean... Any help would be appreciated!)
> 8) should now be able to access data on hdlc0
>
> Does this sound at all correct? Any suggestions, things I am missing?
> There is damn little documentation on this, so most of this I am pulling
> from my short hairs.
>
> Michael Rowley
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users@lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users
>
>
--
Michael Welter
Introspect Telephony Corp.
Denver, Colorado
+1 303 674 2575
mike@introspect.com
www.introspect.com