asterisk users - Apr 2003 - X100P problem

Hi 

  I buy this card just few month ago, but i have a problem when i try to use in
the asterisk pbx the software detect when i plug or unplug the phone cord, but
when i plug the phone cord just 2 seconds later asterisk detect a ring event but
nobody is calling what happend???


Thanks
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20030411/114a1c00/attachment.htm

I am having a problem with the x100p cards.  It doesn't matter whether
the card is in the machine or not, all I get is a busy signal when
calling.  The Asterisk box doesn't give me any errors and doesn't show
that any call is coming through.  I removed the cards from the machine
completely and they still give busy signal when dialed.  Any ideas?

I must say that after dealing with the ordering process with Digium, and
now the seemingly broken cards, I have to say that I completely
frustrated and unhappy with deciding to go with digium.  I think that
Asterisk is probably very cool, and will do what I want, but it took
three weeks to get my cards and the people at digium won't email to save
their lives.  Anyway, please help with the card problem as I feel that I
am out another week and this was supposed to be running last week...

Thanks

Sean Garland
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20031224/b52b8ed2/attachment.htm

Hello, folks,

  I'm having a problem where my X100P isn't behaving
the way I think it should.

  I have the hardware installed fine, with the phone
line connected to the port labeled 'line', and nothing
in the port labeled 'phone'.

  The zaptel and wcfxo modules load fine, and there is
a line in /var/log/mesages indicating the card if
found successfully.

  I followed directions on the Digium site, which
resulted in the following:
I added this line to the end of the stock
/etc/zaptel.conf file:

fxsks=1

I added these lines to the end of the stock
/etc/asterisk/zapata.conf file:

signalling=fxs_ks
context=incoming
channel => 1

So far so good.  The channel shows up in * in the zap
show channels command.

I added this to the end of extensions.conf, to make
debugging easier:

exten => 3000,1,Dial(Zap/1/9728391852)
exten => 3000,2,Congestion

So, if I dial extension 3000 from a working internal
phone, I should dial my cell phone over the zap
channel, right?

However, if I try to dial out, I connect, but get
absolutely nothing.  The cell phone doesn't ring, and
no audio.

If I try to dial in, I get a phone system recording
that says "due to phone system trouble, this call
cannot be completed".

This is the type of thing that I'd expect to get if I
were plugging in the wrong interface (like if the
X100P were for interfacing with phones instead of
phone lines), but I've double checked that.

Anyone have any ideas?  I feel like there is something
obvious I'm missing.

I have not found anything in the wiki, nor in the
mailing list archives.

thanks,
  Shaun





  


		
__________________________________
Do you Yahoo!?
Yahoo! Mail Address AutoComplete - You start. We finish.
http://promotions.yahoo.com/new_mail