Well,
I think, from conversations we''ve been having on this list, that the
first thing to do is to try to disable checksum offloading on your
network cards (supposing that all the other bunch of stuff that can
go wrong, didn''t).
An interesting thing to test is to check if you can connect from
a different *physical* machine on the same network into your guest
domains. If this works, it''s an important data point.
You can do that with:
ethtool -K eth0 rx off
ethtool -K eth0 sx off
ethtool -K eth0 sg off
ethtool -K eth0 tso off
Good luck!
Em Friday 09 September 2005 16:26, John Wilson escreveu:> Hey,
>
> I''m having a bit of difficulty sshing from Dom0 to DomU and vice
versa, my
> setup is as follows;
>
> Xen-3.0-unstable, XenLinux kernel 2.6.12
>
> Dom0 on Redhat EL 4
>
> Dom1 on SuSE linux 9.1 (with the standard xenU kernel included with
> xen-unstable)
>
> The server it runs on doesnt have a nic installed (well it does, just
> without drivers)
>
> the suse config file sets the eth0 interface up as follows;
>
> nics = 1
> ip = "10.0.0.3"
> netmask = "255.255.255.0"
> gateway = "10.0.0.2"
>
> and I have to set the Dom0 vif1.0 interface up myself using;
>
> ifconfig vif1.0 10.0.0.2 netmask 255.255.255.0
>
> Now...
>
> When I ping either way the network connection seems fine (i.e. ping
> 10.0.0.2 from DomU and vice versa), and ssh works fine on both domains
> from both the loopback interface and the vnic ip addresses. However when I
> try to ssh either way from Dom0 to DomU or DomU to Dom0, it fails
> somewhere. Looking at the verbose output from the ssh command shows that
> the domains are connecting to one another and doing a netstat -a on either
> domain after attempting an ssh shows that there is indeed a connection
> between the two, but somewhere along the line the packets are not getting
> through. Basically I''m just not getting a password prompt.
>
> Could anybody give me a little insight into why this is failing?
I''ve also
> tried vncserver/vncviewer both ways and this too fails in a similar
> fashion.
>
> Apologies for the lack of actual output but I''m currently not
sitting by
> the server.
>
> Now the main aim of this whole thing is to eventually vnc into a windows
> vmx domain I''m trying to set up on my VT enabled platform, I have
a
> bootable (using qemu at least) hard disk image of windows and I guess
> vncing into it after doing a ''xm create -f winimg.cfg'' is
the right way of
> doing things?
>
> Thanks in advance,
>
> John
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@lists.xensource.com
> http://lists.xensource.com/xen-users
--
Ramiro Brito Willmersdorf Dep. Engenharia Mecânica/UFPE
ramiro@willmersdorf.net tel: +55 81 2126-8231e239
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users