Yes it's very easy. Mine is using a simulated PRI over an ATT Flex line. I
just followed the many tutorials out there. I answer the call, then it takes 6-7
seconds (you can add a wait if you want) and then it detects it and drops it to
the fax extension in the same context.
Also, until recently I used the Asterisk Fax licensing, but have since switched
to spandsp as that is the supported one ongoing.
-----Original Message-----
From: asterisk-users <asterisk-users-bounces at lists.digium.com> On
Behalf Of Mitch Claborn
Sent: Tuesday, December 11, 2018 9:41 AM
To: asterisk-users at lists.digium.com
Subject: Re: [asterisk-users] DAHDI fax detection
I'm assuming that no one knows the answer to this.
Does anyone have fax detection successfully working? If so, can you share your
configuration?
Mitch
On 12/4/18 4:27 PM, Mitch Claborn wrote:> Asterisk 16 latest
> DAHDI 3.0.0 latest
>
> Excerpt from chan_dahdi.conf is shown below. I'm trying to enable fax
> detection on inbound calls so that I can take appropriate action in the
> dial plan. "dahdi show channel 1" shows "Fax Handled:
no". Does that
> mean that I don't have it configured correctly?
>
>
>
> [channels]
> ; Span 1: WCTE2/0/1 "WCTE23X (PCI) Card 0 Span 1" (MASTER)
ESF/B8ZS RED
> group=10,11
> context=from-pstn
> switchtype = national
> signalling = pri_cpe
> faxdetect=incoming
> faxdetect_timeout=0
> faxbuffers => 12,half
> channel => 1-23
>
> ; Span 2: WCTE2/0/2 "WCTE23X (PCI) Card 0 Span 2" ESF/B8ZS RED
> group=10,12
> context=from-pstn
> switchtype = national
> signalling = pri_cpe
> channel => 25-47
>
>
--
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
Check out the new Asterisk community forum at: https://community.asterisk.org/
New to Asterisk? Start here:
https://wiki.asterisk.org/wiki/display/AST/Getting+Started
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users