Dear all,
I have a PCIe device driver that I have been using on various Linux
distributions and Kernel versions (2.6.x - 3.x.y) successfully all along.
I recently set up a Xen environment with Linux Mint 12 and Xen Hypervisor 4.1.
When I boot to Linux Mint, my driver still load (via insmod manually)
successfully at Dom0 without any issue. I can do reads and write to the
hardware device. But once booted to Xen, the driver failed to complete the
driver load (via insmod manually) at Dom 0 and the console just hangs.
From my debug messages, it appears it hangs because the driver doesn''t
receive any interrupt after a command is sent to the hardware device by writing
a parameter to the mapped register. Once that register is written, the device
is expected to DMA the command from the buffer allocated by the driver.
The things that I can only think of that might have caused the problem are 1)
IRQ mapping issue, or 2) DMA mapping issue, which I am not sure.
What the driver does:
Set up a command buffer:
Buf_t *buf = kmalloc(BUF_SIZE*sizeof(buf_t), GFP_KERNEL);
unsigned long buf_addr = __pa(buf);
unsigned int buf_addr_low = (unsigned int)buf_addr;
Tell device about the buffer:
iowrite32(buf_addr_low, dev->pci_reg_map + BUF_ADR__LOW);
Set up IRQ:
if (pci_find_capability(dev, PCI_CAP_ID_MSI) &&
(!pci_enable_msi(dev)))
{
if (request_irq(dev->irq, func_msi_interrupt, IRQF_SHARED,
DRIVER_NAME, my_dev))
{
return -ENODEV;
}
my_dev->intr_mode = INTERRUPT_MSI;
}
Ask device to fetch command from buffer (Expect interrupt after this after
device fetched the command from buf. But interrupt did not happen.):
iowrite32(buf_offset, dev->pci_reg_map + FETCH_CMD_REG);
From dmesg, it looks like IRQ initialization is complete.
[ 241.743769] My_driver initialization
[ 241.743787] xen: registering gsi 16 triggering 0 polarity 1
[ 241.743793] xen_map_pirq_gsi: returning irq 16 for gsi 16
[ 241.743795] xen: --> pirq=16 -> irq=16 (gsi=16)
[ 241.743801] Already setup the GSI :16
[ 241.743805] my-driver 0000:02:00.0: PCI INT A -> GSI 16 (level, low) ->
IRQ 16
[ 241.743815] my-driver 0000:02:00.0: setting latency timer to 64
/proc/interrupts:
CPU0 CPU1 CPU2 CPU3 CPU4 CPU5
CPU6 CPU7
......
......
339: 0 0 0 0 0 0
0 0 xen-pirq-msi my-driver
......
......
Any idea what might cause the problem?
Is there anything we have to be enable/disable, use different functions, or do
differently in drivers written for Xen Dom0 environment regarding the following?
1) Allocating a DMA buffer in driver to allow the device to DMA stuffs.
2) Requesting MSI irq.
Please advise!
Thanks a lot in advance!!
Kenneth
_______________________________________________
Xen-users mailing list
Xen-users@lists.xen.org
http://lists.xen.org/xen-users