Hi Doug,
Replace your console type from 'file' to 'pty' it looks like
this:
<serial type='pty'>
<target port='0'/>
</serial>
<console type='pty'>
<target port='0'/>
</console>
And then append the parameter "console=ttyS0,115200" to guest kernel
cmdline and reboot your guest, to use virsh console to connect your
guest again.
For details, please refer to the following link:
http://libvirt.org/formatdomain.html#elementsConsole
Good Luck!
Alex
----- Original Message -----
From: "Doug Goldstein" <cardoe at gentoo.org>
To: libvirt-users at redhat.com
Sent: Wednesday, May 9, 2012 6:03:57 AM
Subject: [libvirt-users] virsh console logging and pty usage
Is it possible to both log the serial console and to actually use it?
A few of the VMs I've got are configured as follows:
<serial type='file'>
<source
path='/var/log/libvirt/qemu/serial/bb-2.6.18-128.el5-x86_64.log'/>
<target port='0'/>
</serial>
<console type='file'>
<source
path='/var/log/libvirt/qemu/serial/bb-2.6.18-128.el5-x86_64.log'/>
<target type='serial' port='0'/>
</console>
Because people are hoping to capture the logs after the fact to see if
there was any console output which could help them debug an issue.
However, if you need to connect to the console of the VM its
impossible (e.g. it needs the root password for a fsck).
Any suggestions to allow logging but allow it to be usable via "virsh
console" as well?
Thanks.
--
Doug Goldstein
_______________________________________________
libvirt-users mailing list
libvirt-users at redhat.com
https://www.redhat.com/mailman/listinfo/libvirt-users