I'm installing TE405P card.
This is my zaptel.conf.
--------------------------------------
span=1,0,0,ccs,hdb3,crc4
span=2,1,0,ccs,hdb3,crc4
span=3,0,0,ccs,hdb3,crc4
span=4,0,0,ccs,hdb3,crc4
loadzone = us
defaultzone= us
--------------------------------------
When i modprobe wct4xxp,
--------------------------------------
PCI: Found IRQ 11 for device 02:0b.0
PCI: Sharing IRQ 11 with 00:1d.7
Found TE410P at base address ed800000, remapped to e0951000
TE410P version c01a009b
FALC version: 00000005, Board ID: 00
Reg 0: 0x1ad4b800
Reg 1: 0x1ad4b000
Reg 2: 0x07fc07fc
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0x00000000
Reg 6: 0xc01a009b
Reg 7: 0x00001000
Reg 8: 0x00000000
Reg 9: 0x00ff0000
Reg 10: 0x00000000
TE410P: Launching card: 0
TE410P: Setting up global serial parameters
Found a Wildcard: Wildcard TE410P-Xilinx
Registered tone zone 0 (United States / North America)
TE410P: Span 1 configured for ESF/B8ZS
TE410P: Span 2 configured for ESF/B8ZS
SPAN 2: Primary Sync Source
TE410P: Span 3 configured for ESF/B8ZS
TE410P: Span 4 configured for ESF/B8ZS
wct4xxp: Setting yellow alarm on span 1
wct4xxp: Setting yellow alarm on span 2
wct4xxp: Setting yellow alarm on span 3
wct4xxp: Setting yellow alarm on span 4
--------------------------------------
I have two questions.
- Is TE410P is same as TE405P, or did I received different card?
- zaptel.conf is configured CCS/HDB3. But It's configured as ESF/B8ZS.
Hong
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20040718/cfd38369/attachment.htm