I've found out how to accomplish this... I'm sending this to the list
in case someone need this too:
Disclaimer: this worked for me, no warranty provided etc...
* Disconnect the power
* Open the cover
* In the middle, there's a JP1, with three pins, one side is marked DBUG
(pin 1), find a regular jumer, and jump pin 1 & 2.
* Connect the power, in the terminal connected to the serial port,
you'll see you're now dropped in the debug console immediately
* you can type ? or h to get a list of help command
* the commands worked for me are to erase both data storage 1 and 2:
e s 1
e s 2
* then remove the jumber, and type q
* now zhone boots up to it's default config, and I can login as
admin/zhone again
Happy hacking :)
On Tue, Sep 30, 2003 at 10:09:12PM -0400, Yifang Dai
wrote:> I've just received a brand new zhone z-plex 10b. At first, I was able
to
> login using the default (admin/zhone), and started exploring with
> the configuration, trying to set it up to work with the TE410P.
>
> Somehow the admin password was changed, but I don't
> know what it is anymore. So now I'm stuck at the login prompt, and
can't
> get back to the CLI.... Is there a way to reset the unit to factory
> default? Or get to the CLI without the password? Thanks in advance for the
help...
>
>
> Yifang
--
Yifang Dai |
eFax: (847)628-0255 | Debian GNU/Linux
yifang_dai@yahoo.com |