On 16 November 2011 18:49, Flavio <fbcyborg@gmail.com>
wrote:> I will keep you up to date.
The installation has finished. The virtual machine has stopped after the
setup has finished and the following message appeared:
> openSUSE Installation
>
> - there are shells running on consoles 2, 5, 6, 9
> - use ''extend'' to load extensions (remove with
''extend -r''); extensions are:
> o bind, gdb
> - network setup: run, e.g. ''dhcpcd eth0''
> - sshd: run ''rcsshd start'' (don''t forget to set
a password with ''passwd'')
>
> 192:~ # yast
> unicode_start skipped on /dev/pts/0
> Probing connected terminal...
>
> Initializing virtual console...
>
> Found an xterm terminal on /dev/pts/0 (136 columns x 48 lines).
> *** Starting YaST2 ***
here I proceeded with the installation and when it finished I''ve got:
>
> *** Preparing SSH installation for reboot ***
> *** NOTE: after reboot, you have to reconnect and call ***
> *** /usr/lib/YaST2/startup/YaST2.ssh ***
> unicode_stop skipped on /dev/pts/0
I tried to reboot, using the same config file, but I couldn''t perform
such
command. At this point, the setup has finished but I don''t know how to
proceed to start the domU.
Actually if I use the following config file:
name="OpenSuse11"
memory=1024
disk =
[''phy:/dev/loop0,hdc:cdrom,r'',''file:/mnt/xen/vmstore/opensuse11/opensuse11.img,xvda,w''
]
vif = [ ''type=ioemu, mac=00:16:3e:00:00:21, bridge=xenbr0'' ]
vfb = [ "type=vnc,vncunused=1,vnclisten=0.0.0.0,keymap=it" ]
stdvga=1
videoram=16
bootloader = "/usr/bin/pygrub"
vcpus=1
on_reboot = ''restart''
on_crash = ''restart''
I see this error:
failed to run bootloader: -3
Suggestions?
--
Flavio
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users