>
> I have one physical eth0 interface on a server running xen. I need to
have> two IP addresses bound to the physical interface at the server layer
(not> vm). I basically want to do in Xen what would be referred to as a
virtual IP> in unix/linux. I can do this at the RHEL os level via the following
> commands:
>
> #ifconfig eth0 inet 192.168.177.25 netmask 255.255.255.0 up
> #ifconfig eth0:0 inet 10.68.177.25 netmask 255.255.255.0 up
>
> This works fine before xen starts but once I start xen, the second
interface> (0:0) gets dropped.
>
> The reason I need this is to route db interconnect traffic over the
192> network while routing the public traffic over the 10 network.
>
> I don''t understand how to accomplish this without xen stomping on
it.
>
Don''t let xen automatically configure your network adapter. The
autoconfig stuff is great if you boot between xen and non-xen
configurations, but if you are always using xen just do it yourself.
Configure the bridge as part of your init (eg /etc/network/interfaces
under Debian) and put your IP addresses etc on that, and then comment
out any reference to ''network-script'' in
/etc/xen/xend-config.sxp.
James
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users