Xen devel - Oct 2005 - RE: xen dom0 failed to boot up if compiled with "framepointer" enabled

> I need to compile xen0 with frame pointer switch on. But the 
> compiled kernel cannot boot up with panic message.
> 
> Any thought about this?
I''ve done this within the last month without problems. Did you do a
make
ARCH=xen clean beforehand?

Ian

_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xensource.com
http://lists.xensource.com/xen-devel

Yes. I did. the frame pointer works with domU, but not dom0. I will
probably try again.

Thanks,

Xin


On Mon, 3 Oct 2005, Ian Pratt wrote:
> > I need to compile xen0 with frame pointer switch on. But the
> > compiled kernel cannot boot up with panic message.
> >
> > Any thought about this?
>
> I''ve done this within the last month without problems. Did you do
a make
> ARCH=xen clean beforehand?
>
> Ian
>
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@lists.xensource.com
> http://lists.xensource.com/xen-devel
>
_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xensource.com
http://lists.xensource.com/xen-devel