Xen 3.0 startup hangs on mptbase error: "mptbase: Initiating ioc0
recovery"
It seams there''s problem when booting from a fc attached storage
system.
Here the interesting enty in /etc/sysconfig/kernel:
INITRD_MODULES="ata_piix mptspi qla2300 processor thermal fan
reiserfs"
Without mptspi the qla2300 driver doesn''t find any devices. Is mptspi
needed
for qla2300 or is the qla2300 problem an other problem? However, without Xen
both drivers will work fine:
Fusion MPT base driver 3.03.02
Copyright (c) 1999-2005 LSI Logic Corporation
mptspi: module not supported by Novell, setting U taint flag.
Fusion MPT SPI Host driver 3.03.02
mptbase: Initiating ioc0 bringup
ioc0: 53C1030: Capabilities={Initiator}
scsi2 : ioc0: LSI53C1030, FwRev=01032316h, Ports=1, MaxQ=222, IRQ=177
Vendor: IBM Model: 25P3495a S320 1 Rev: 1
Type: Processor ANSI SCSI revision: 02
Attached scsi generic sg1 at scsi2, channel 0, id 8, lun 0, type 3
QLogic Fibre Channel HBA Driver
qla2300 0000:04:02.0: Found an ISP2312, irq 169, iobase 0xf8834000
qla2300 0000:04:02.0: Configuring PCI space...
qla2300 0000:04:02.0: Configure NVRAM parameters...
qla2300 0000:04:02.0: Verifying loaded RISC code...
qla2300 0000:04:02.0: Waiting for LIP to complete...
qla2300 0000:04:02.0: LIP reset occured (f7f7).
qla2300 0000:04:02.0: LOOP UP detected (2 Gbps).
qla2300 0000:04:02.0: Topology - (F_Port), Host Loop address 0xffff
scsi3 : qla2xxx
qla2300 0000:04:02.0:
QLogic Fibre Channel HBA Driver: 8.01.00b5-k
QLogic QLA2340 - 133MHz PCI-X to 2Gb FC, Single Channel
ISP2312: PCI-X (100 MHz) @ 0000:04:02.0 hdma+, host#=3, fw=3.03.15 IPX
qla2300 0000:05:01.0: Found an ISP2312, irq 185, iobase 0xf8836000
qla2300 0000:05:01.0: Configuring PCI space...
qla2300 0000:05:01.0: Configure NVRAM parameters...
qla2300 0000:05:01.0: Verifying loaded RISC code...
qla2300 0000:05:01.0: Waiting for LIP to complete...
Vendor: IBM Model: 1722-600 Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB)
SCSI device sda: drive cache: write back
sda: sda1 sda2 sda3 sda4
Attached scsi disk sda at scsi3, channel 0, id 0, lun 0
Attached scsi generic sg2 at scsi3, channel 0, id 0, lun 0, type 0
Vendor: IBM Model: 1722-600 Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sdb: 629145600 512-byte hdwr sectors (322123 MB)
SCSI device sdb: drive cache: write back
SCSI device sdb: 629145600 512-byte hdwr sectors (322123 MB)
SCSI device sdb: drive cache: write back
sdb: sdb1
Attached scsi disk sdb at scsi3, channel 0, id 0, lun 1
Attached scsi generic sg3 at scsi3, channel 0, id 0, lun 1, type 0
Vendor: IBM Model: 1722-600 Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sdc: 10485760 512-byte hdwr sectors (5369 MB)
SCSI device sdc: drive cache: write back
SCSI device sdc: 10485760 512-byte hdwr sectors (5369 MB)
SCSI device sdc: drive cache: write back
sdc: sdc1 sdc2
Attached scsi disk sdc at scsi3, channel 0, id 0, lun 2
Attached scsi generic sg4 at scsi3, channel 0, id 0, lun 2, type 0
Vendor: IBM Model: 1722-600 Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sdd: 10485760 512-byte hdwr sectors (5369 MB)
SCSI device sdd: drive cache: write back
SCSI device sdd: 10485760 512-byte hdwr sectors (5369 MB)
SCSI device sdd: drive cache: write back
sdd: sdd1 sdd2
Attached scsi disk sdd at scsi3, channel 0, id 0, lun 3
Attached scsi generic sg5 at scsi3, channel 0, id 0, lun 3, type 0
Vendor: IBM Model: 1722-600 Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sde: 10485760 512-byte hdwr sectors (5369 MB)
SCSI device sde: drive cache: write back
SCSI device sde: 10485760 512-byte hdwr sectors (5369 MB)
SCSI device sde: drive cache: write back
sde: sde1 sde2
Attached scsi disk sde at scsi3, channel 0, id 0, lun 4
Attached scsi generic sg6 at scsi3, channel 0, id 0, lun 4, type 0
Vendor: IBM Model: 1722-600 Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sdf: 151399694 512-byte hdwr sectors (77517 MB)
SCSI device sdf: drive cache: write back
SCSI device sdf: 151399694 512-byte hdwr sectors (77517 MB)
SCSI device sdf: drive cache: write back
sdf: sdf1 sdf2
Attached scsi disk sdf at scsi3, channel 0, id 0, lun 5
Attached scsi generic sg7 at scsi3, channel 0, id 0, lun 5, type 0
Vendor: IBM Model: Universal Xport Rev: 0520
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sdg: 40960 512-byte hdwr sectors (21 MB)
SCSI device sdg: drive cache: write through
SCSI device sdg: 40960 512-byte hdwr sectors (21 MB)
SCSI device sdg: drive cache: write through
sdg: unknown partition table
Attached scsi disk sdg at scsi3, channel 0, id 0, lun 31
Attached scsi generic sg8 at scsi3, channel 0, id 0, lun 31, type 0
Vendor: IBM Model: ULT3580-TD2 Rev: 4772
Type: Sequential-Access ANSI SCSI revision: 03
Attached scsi generic sg9 at scsi3, channel 0, id 1, lun 0, type 1
st: Version 20050501, fixed bufsize 32768, s/g segs 256
Vendor: IBM Model: ULT3581-TA2 Rev: 3.00
Type: Medium Changer ANSI SCSI revision: 02
Attached scsi generic sg10 at scsi3, channel 0, id 1, lun 1, type 8
Attached scsi tape st0 at scsi3, channel 0, id 1, lun 0
...
I have no such problems with Xen 2.0.7.
Stephan
_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xensource.com
http://lists.xensource.com/xen-devel