similar to: Intel PRO/Wireless LAN 2100 Adapter

Hello This might not be a 'pure' * question, but it is relevant to general VOIP technology. I tried x-lite on my notebook with wireless connection(802.11). The software has been tested with the fixed line connection. It worked fine to call through *. When using wireless connection, it is clear on my side using notebook; however, there is loud noise on the other side of the call which uses

I am going to be setting up an Intel 2200bg card this evening. I was wondering if anyone is using this (successfully) with CentOS 4. The directions look straightforward, but please let me know if you had to do anything interesting/undocumented to make it work. I am also wondering if people are using the driver provided with the current CentOS 4 kernel or if people are using the most recent

Hi folks I'm having some hard time troubleshooting a Wifi issue Centos7, fully up to date, with an Intel Dual Band 3160 Wireless adapter After the machine boots, the Wifi connects and runs ok for a few hours After this, the Wifi just stops [root at orbex ~]# lspci -v | grep Wireless 04:00.0 Network controller: Intel Corporation Wireless 3160 (rev 83) Subsystem: Intel Corporation

Hi all and greetings from Australia, I am looking at a suitable VPN to secure a wireless notebook hanging off a private, wired network. Is tinc suitable for this? specifics: "notebook" 192.168.205.63 "AProuter" (access point/computer that the notebook will connect to): 192.168.205.31 What numbers should I give to the various nodes? At this stage, only one notebook VPN:ed

Using CentOS 5 - installed ipw2200 firmware and tried to set up new eth1 wifi device, but adapter Intel Coporation PRO/Wireless 2200BG doesn't show up in list of adapters when I try add New Device (ipw2200 does show up on hardware tab as ipw2200 eth1 ethernet configured). I've noticed that when I run system-config-network on command line, these errors show up:

Is there any way I can find a driver and/or get the above wireless card working in CentOS 5 on my Dell laptop (Inspiron 1501). I've installed ipw2200 from RPMForge, but it now appears that this won't work because the card is not an Intel PRO/Wireless card. Dell seem to support only MS Windows Vista now so I don't think there's much chance of getting a driver from them - so am I on

Hi all, I've got a Dell Inspiron 1501 with a Broadcom 1390 Wlan mini card (integrated) wireless lan chipset. I've got an init script setup to activate the wireless connection at boot time, however when the system boots the adapter doesn't connect. I'm not able to get a connection until after the desktop is done loading and I run the script from the command line. After some

Installed CentOS 5 on my Dell Inspiron 1501 laptop, hoping that it will be easier to set up wireless networking than it was in CentOS 4.4. But still sooooo difficult to get it working, mainly because there doesn't appear to be a driver pre-installed for this wireless card ((Dell wireless 1390 Mini PCI network card 802.11b/g). Do I still have to use ipw2200 and what is this anyway? - I really

Hello David, In brief, I've solved this problem on my Dell Inspiron 1525 (with Broadcom 4312 wireless card), so I figured letting You know would be nice, 'cause it didn't seem like the issue is resolved. Visit this link: http://jomcode.com/fadhil/?p=59 and in addition check out the comment on the same page by Andre Kiepe to have the modules load on boot. Best Regards, Milos.

All. I just got my new 2100 from dell. Nice little box. PLugged my centos 4.1 in and went rather smooth. However, my X windows screen flickers. I noticed it did the vesa driver. SO I went out to intel and downloaded the mobile 915 for linux. Followed the install directions. and it spit a couple errors about not succeeding. Nothing useful in the text. My laptop is still in vesa mode. Has anyone

>Jerry Geis wrote: >>/ All, />>/ />>/ Over the weekend I purchased a linksys wireless-g PCI card />>/ for use in my amd64 box. I downloaded ndiswrapper, compiled, installed, />>/ tried to load the driver off the CDROM and it was a no-go. />>/ />>/ I have do this on another box with an amd sempron. Difference being />>/ 32 bit versus 64 bit...

In 5100 and 1100 series Inspirons Intel 2915abg cards work MUCH cooler than the original Broadcoms, don't choke up in hot weather like the original Dell cards and don't require ndiswrapper. (All of 2 Notebooks were tested outdoors at 98 deg F ambient. Dropouts occured in both Centos 4.4 & XP on these dual boot notebooks with the Dell Mini-PCI's, none with 2915's). The only

Hi all, When I first loaded C6 on my Dell Inspiron laptop the wireless worked flawlessly right out of the box. At the time the wireless access point was a Linksys WAP54G using WPA-2 Personal. In the last two weeks that Access point has been replaced with a Linksys WAP610N, also using WPA-2 Peronal. The problem I'm having is the wireless adapter sees the new WAP just fine, but is unable

Hi there I am just writing to find out if anyone else had an issue installing CentOS 5 on an inspiron notebook. If I choose Desktop - Gnome in the distribution selection, after the "transferring image to hard disk" message it waits a very long time than dies with an error about not being able to run the transaction due to the following error: Press enter to reboot. I am able

-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi there, I just wondered if there is an open-source way of getting information about the temperatures provided by the internal sensors. I've read that nvclock is providing such information but only if the binary driver is installed and used. When I run 'sensors-detect' is see three adapters provided through nouveau: ... Next adapter:

On Sat, September 10, 2016 12:12 pm, Arun Khan wrote: > On Fri, Sep 9, 2016 at 3:40 AM, C. L. Martinez <carlopmart at gmail.com> > wrote: >> Hi all, >> >> I would like to install/test CentOS 7.X as a hostap for my home. I am >> thinking to use an Alfa (http://www.alfa.com.tw) usb wireless adapter >> or TP-Link. >>BUt there is not much information in

Is there any issues with running icecast on a wireless lan. My friend has the encoder on 1 machine and is feeding it to icecast over a wireless nic to another machine which is connected to a router via a wired NIC but after the feeds been on for awhile it starts buffering. -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= Weather @ 8:00pm - Temp: 17.0 ?C - Humidity 55 %

Hi, there, I tried to install Centos 5.1 on a Dell Inspiron 530 box I just bought, but failed due to invalid drive. The installation did not recognize either the DVD nor the hard disk. Joseph from the community said it is likely that Centos can't recognize the controller -- Intel SATA controller (cmiiw). Did anyone solve this problem before? How did you do it? Here's the related

Hi all, I am trying to use usb passthrough for an usb wireless adapter to a kvm guest under a CentOS7 host. Guest can connect to an AP and sometimes receives an IP and sometimes not. But when and IP address is assigned by an AP (and defaultroute), nothing works. If I try to resolv any host like for example www.google.com, there is no result ... Trying to ping 8.8.8.8 doesn't works also.

Hi!. I recently buy a new notebook, and install CentOS 4.3 on it. This because I'm in charge of a lot a servers with Centos installed, and want to use only one distro in all my machines. And, because of course I really like Centos for desktop too. :) The notebook comes with Intel GMA 950 video graphics. I can use it with the vesa driver of Xorg, but I also want 3D graphics, for some