similar to: Nortel Option 11

Situation: * New Install of Asterisk * 7960 w/ SIP 7.4 Image * 7912 w/ SIP040406A * 3 Lines Defined on the 7960 (5104,3100,2100) Questions (configs are below): * Why won't the MWI light on the Cisco? I've tried: * mailbox=2100 * mailbox=2100@default * mailbox=2100@wvlandsales-voicemail * Does anything look goofy overall? :-) Thanks, George Sip.conf [2100]

We've been trying unsuccessfully to connect our Meridian Option 81C to a TE110P via PRI. We've followed the directions in asterisk-meridian-a1.pdf (link on http://www.voip-info.org/wiki/view/Asterisk+legacy+integration), but it doesn't seem to work on our 81C (even though many, many users report it works very well on Option 11's). Has anyone had any success in getting the above

I am trying to integrate a Nortel Norstar system with an Asterisk service using a TDM04B card (4 fxo). So far everyting works from Asterisk to Nortel. The problem is when someone dials from the Nortel PBX to the Asterisk server. Asterisk answers the call and provides a dialtone (with DISA) but appartently the DTMF tones are not passed to asterisk and the call cannot proceed. This only

We are currently working to trunk from a Nortel 81C to an Asterisk Server 1.4 running on Red Hat Linux. We have two PRI trunks which work with the exception of the clock slips, which is causing the Nortel to reset the PRIs once a hour. Thanks for any suggestions. 81C MSDL Asterisk Digium TE110P REQ prt TYPE adan dch 10

Does anyone know the default E&M Wink timings for Nortel DID ports? The default settings on Asterisk are: ; prewink: Pre-wink time (default 50ms) ; preflash: Pre-flash time (default 50ms) ; wink: Wink time (default 150ms) ; flash: Flash time (default 750ms) ; start: Start time (default 1500ms) ; rxwink: Receiver wink time (default 300ms) ;

Well I am entering into a realm that I don't know. 3 sites with Asterisk 1 site with Nortel Asterisk/Sip calls working fine between the 3 sites. Asterisk to Nortel set calls working fine. (call comes from asterisk to nortel and rings telephone, people answer and talk happens, hangup call clears) Nortel to Asterisk. Set on Nortel gets a busy signal. Any suggestions on what to look

Is anyone successfully using this phone with Asterisk? There is a lot mentioned about CISCO but nothing about Nortel... Alex.

Hello to all, I have a problem with an asterisk qsig. I have three machines: Nortel CS1000 --- Card Sangoma PRI ---> Asterisk QSIG ---SIP Trunk---> Asterisk I use Snom phones on Asterisk. If I call from Asterisk to Nortel, Nortel reminds me of the name of the person i'm calling and I visualize on the display of Snom phone, but if I call from Nortel to Asterisk, the QSIG does not send

I am using asterisk 1.4.32 and wish to connect using SIP to a nortel 1000 switch with the ability to have 90 calls at a one time outgoing or incoming. the nortel reseller is asking me what to do. I dont know nortel at all. I thought I just needed a "SIP trunk and IP address of the their server and an account name, and provide her my IP address". They didn't know what to do with

Dear List, Need to know if anyone on this list has had any experience with using the Nortel BCM 50 for Call Account Reporting using an IP connection to a Linux / Asterisk interface? Presently, I have a BCM 50 installed that uses a local Lenova Small Form Factor PC with a windows XP / os that quit reporting because of a up-grade to the Nortel reporting software. Nortel support is now telling

I have gone through some archive about Nortel MICS (Meridian ?)+ Asterisk Integration but I'm not sure whether same as my case . 70 telephone sets | | Nortel MICS 4.1 --------- Asterisk | PSTN I have read the David Gomillion's Guide and got the idea . However, my plan is slightly different from what he did , I need to use Nortel MICS to connect to PSTN (I

Hello, I am wondering if anyone is using the Nortel 2001 2002 or 2004 phones on their asterisk implementation. My local dealer says they are not compatible with any open source implementations. Is there a phone compatibility list somewhere? Cheers Cian

Has anyone had any luck getting an asterisk box to talk to a Nortel C15K softswitch? Or any Nortel "sip" products? I've been playing with it for several days and can't seem to pass calls either direction. I know that whike the Nortel says the C15K speaks SIP, it really speaks nortel's implementation of SIP, but I thought I could get it to at least pass simple calls back

Anyone interfaced * to the Nortel option 61c pbx via T1's, pri, etc? Need to begin planning the implementation, purchase cards, etc. Any recommended approaches, configuration problems, etc? Off-list is fine if you'd like. Rich radamson @ routers . com

This are "suppose" to be SIP based phones. I just got one to play with, no docs, no nothing. before I start spending time trying to sort it out I thought I'd ask to see if anyone had made one work with AST, and if they have any pearls of wisdom. mucho thanks

folk, I see from the archives that the issue of nortel handsets not sending dtmf tones to asterisk has been discussed a couple of times, but there is something I quite havent seen answered yet. Is this dtmf issue a problem with the nortel handsets or the PBX itself? If the handset were changed to another one, would this issue be solved? Or must the PBX be changed completely? rgds eb

Hi, I have asterisk running a single T1 card with a connection to a nortel CS 1000. All calls to extensions, local and long distance are working just fine. My issue is this: The nortel CS 1000 supports connections to and intercom system that is just line level audio to speakers. When my PRI tries to call this "extension" it is never answered so my AGI never runs to play a message

Is anybody using Nortel IP Phone? I have (second hand) Nortel i2002 phone and when it boots I get: DHCP server unreachable F/W version: 0604D9C My setting: DHCP? [0-No, 1-Yes]: 1 DHCP: 0-Full, 1-Partial: 0 Can any body suggest how to troubleshoot it? -- #Joseph GPG KeyID: ED0E1FB7

Anyone get the Nortel 1140E phones working with Asterisk ? These look like great phones and I would like to start using them on our deployments. I know these will work with Asterisk but the sample config files are hard to find. My next step, if I cant find anything on this list is to purchase a Nortel Communication Server for testing. If anyone has a used NCS that works with these phone via SIP

Has anyone fed a Nortel BCM from Asterisk? I'm interested in switching our company over, but don't want to replace all the handsets in one fell swoop. I imagine some of the PRI cards can "emulate" a switch? I'd still like to pass CallerID into the Nortel, etc but all the external traffic would be VOIP, not TDM.