similar to: SS7 for *

Hi, one month ago, I announced, that I will look at the openss7 project in order to use it together with asterisk. It took a while for me to check the capabilities of and around the project. Since the openss7 project consists of only one person, and when there was just silence for a long time in the project's mailing list, I doubted, whether it was a good idea to consider using openss7. In

Hi, there are still some questions to be answered by OpenSS7.com in order to decide, whether E400P-SS7 is a good choice for the asterisk SS7 support. In the meanwhile I'm also in negotiations with another manufacturer (whose name I currently may not tell due to a NDA) of SS7 hardware, who gets likely persuaded to offer a cheap SS7-PCI-card which would be suitable for asterisk. Asterisk users

Hi, Does Asterisk support SS7? Google shows an old new post from Feb. 2002 stating that OpenSS7 would help add SS7 support to Asterisk, but presently OpenSS7 seems to be dead and I can't seem to find anything about it at Asterisk or Digium's sites. What happened? -- Regards, Tais M. Hansen ComX

Hi, I'm looking into support for SS7 and I found an article (http://www.openss7.com/news13022002.html) which says that OpenSS7 supports Linux Support Inc's T400P-SS7 Quad T1 and E400P-SS7 Quad E1 PCI interface cards. It also says that Linux Support Inc is the primary sponsor of Asterisk. However I cannot find these cards on the Asterisk hardware page

Hi, Is this card the same as the T410P, after all, it's made by Digium. There's one prior reference on the mailint list[1] but it didn't answer the question. There was also an SS7 status report[2] last June but it's doesn't seem to have lead anywhere either. There was post saying an SS7 release was immenent last September[3], but then silence. Any info anyone would like to

Hi, I've posted this question on OpenSS7 mailing list but I didn't get a clear answer. I have a system running asterisk using Digium T400P card. Can this same card be used with OpenSS7 project to carry SS7 links? Is there any difference between these two cards? -- Matteo D'Amato Network/Telecom Administrator Intelco Communication Inc

The "--disable-strip" configure option is required as the Solaris9-X86 linker/loader will not be able to load any of the executables and will display a "Killed" message. Similarly, 'ldd' will fail with a "file has insecure interpreter" error message. Performing a loader or ldd test from the OpenSSH installation directory on the compiled executables within the

Hello, We are looking for commercial solution SS7 with Asterisk. It does not need to be "build-in" with Asterisk. Could anybody suggest something? Thank you in advance. Bart

Hello.. I have a customer who wants to connect 2 PBX's over IP.. The setup should look like this: [PBX] <-- SS7 --> [Asterisk] <-- IAX --> [Asterisk] <-- SS7 --> [PBX] Since there are no SS7 cards , I was thinking at a way of carrying the E1 data as bulk...Can I do that ? How ? Is possible a scenario like this ? I'm thinking of IAX because I don't

Hello. I am new to this forum. If this issue has been discussed already, please inform me, but my STFW have indicated that it has not. If SS7 were available on * would it make commercial sense to use it? There are case studies on the web (courtesy of the Death Star :->) for ISPs with 10,000+ subscriber lines showing clear cost savings in transitioning from PRI to SS7 controlled IMT. My

Has anyone tried to get dialogic ss7 trunking to work with Asterisk? I did some googling but nothing helpful turned up... Could a person get an intel dialogic and get * to see it like a zap channel? And use it for incoming and outgoing trunk access? -- respectfully, Joseph ------=============

Does anyone know of a device that will take an SS7 link and convert it to a PRI? -- respectfully, Joseph - (606) 477-2355 x140 ------=============

Hey All, I'm just daydreaming here.. but what's the status of SIP-T in Asterisk? I haven't been able to find a whole lot of info on SIP-T but seems like just an extension of SIP. Right? Now if I had a PSTN Gateway (that is a SS7 gateway) that supported SIP-T, could I signal * with SIP-T from it and have asterisk utilize MGCP to sieze a particular DS0 on a remote DS1? Hmm.. What am

In reference to an old post from 2002: http://www.marko.net/asterisk/archives/0203/0103.html How does one go about doing this? Also, what is the present status of the OpenSS7 stack in Asterisk? What can it do now? And is there any possibility in the future of developing a DS3 card for it, if only for the purpose of mostly DACSing? Which is still a level of intelligent call control on the

Hi, Would just like to inquire if anyone here has a setup of asterisk to send traffic to AS5400 connected to an SS7-PRI.? this is more of a AS54 question, as i've been reading and i always stumble upon PGW2200 as a requirement to handle SS7 signaling on the AS54. Has anyone able to send calls from asterisk to an as 54 with SS7-PRI without PGW2200? TIA Regards, Nhadie --------------

I thought everyone should know this. Jorge, After reading your page in the http://voip-info.org/tiki-index.php?page=Asterisk+SS7 please advise Your U.S. customers that SS7 is not done the same way as in the rest of the world and the requirements are different. The U.S carrier's require 2 redundant links. I know this first hand because we run an SS7 network. CARDOSO Jorge Miguel wrote:

Hi, I am requesting for a E1 connection from my telco. They are asking if I want DSS1 or SS7, and I am stuck here. Could someone tell me the difference between the two? How should I decide which one to use? Thanks in advance for your help. Mark -------------- next part -------------- An HTML attachment was scrubbed... URL:

hi can someone recommend a book about ISDN and SS7? I've been hacking asterisk for a while, but it'd be good to get some better background within things... thanks roy

Hi all, I'm being requested to deploy an?IVR service?using SS7. I've deployed Asterisk before using ISDN connection, but never with SS7. Can anyone explain me the different between using ISDN and SS7 ? What need I do now to change to use SS7 ?. Many thanks, Giang -------------- next part -------------- An HTML attachment was scrubbed... URL:

hi some time ago, I asked the list of a good book for learning ISDN and SS7. I don't need to know how to write a channel driver or something; I just want to know more about the possibilities and what's really sent back and forth. I was told the book "ISDN and SS7: Architectures for Digital Signaling Networks" by Uyless Black (ISBN 0132591936) was a good choice, but this