search for: routers

Hi all, Does any one know if this is normal operating of ARP. Or where to start looking. I am seeing a lot of ARP requests for my router IP from the same IP within seconds. 21:04:41.112929 arp who-has IP tell MY ROUTERS IP 21:04:41.186354 arp who-has IP tell MY ROUTERS IP 21:04:41.372972 arp who-has IP tell MY ROUTERS IP 21:04:41.546921 arp who-has IP tell MY ROUTERS IP 21:04:41.640253 arp who-has IP tell MY ROUTERS IP 21:04:42.104746 arp who-has IP tell MY ROUTERS IP 21:04:42.208952 arp who-has IP tell MY R...

I am running tinc v. 1.1pre (truly as I read somewhere, ?one of the internet?s best kept secrets?) on some consumer home routers flashed with tomato firmware. I have a whole network of these, but for the purposes of this question I will focus on just three Router A (subnet 192.168.5.0/24) is connected via a standard tinc ?router? mode network with Router B (subnet 192.168.15.0/24). Router B, in addition to its connection w...

Hello. I'm running RH 7.1, with Samba 2.2.2. VERY often I get a SIGHUP to smbd and it'll dump the workgroups. I also get a "Discarding datagram from IP 216.202.200.103. Source name ROUTER<00> is one of our names" all the time also. This line FILLS my logs. I don't understand this one, because I have the interfaces line specified in smb.conf to use only the local

...pinging (my laptop) got no reply, though if I instead ping hosts directly connected to B, it works fine. > On 4 June 2015 at 20:53, pjv <pjv at pjv.me> wrote: >> I am running tinc v. 1.1pre (truly as I read somewhere, ?one of the internet?s best kept secrets?) on some consumer home routers flashed with tomato firmware. I have a whole network of these, but for the purposes of this question I will focus on just three >> >> Router A (subnet 192.168.5.0/24) is connected via a standard tinc ?router? mode network with Router B (subnet 192.168.15.0/24). >> >> Route...

...the interface of the "switch" tinc. It should make it easier to see where the packets are getting lost. On 4 June 2015 at 20:53, pjv <pjv at pjv.me> wrote: > I am running tinc v. 1.1pre (truly as I read somewhere, ?one of the internet?s best kept secrets?) on some consumer home routers flashed with tomato firmware. I have a whole network of these, but for the purposes of this question I will focus on just three > > Router A (subnet 192.168.5.0/24) is connected via a standard tinc ?router? mode network with Router B (subnet 192.168.15.0/24). > > Router B, in addition t...

I have a rather unusual setup within which I'd like to run samba. At this point I have: a) 3 networks (all private IP's) b) net1, net2 are interconnected by a router. net1 has a host that also acts as a WINS server and is local master, domain master, preferred master for it's group. (linux slack7.0, samba 2.0.5) router between net1, net2 has an IP in each network and samba

I am setting up 2 Vyatta routers that will serve as redundant failover core routers out to the backbone of our ISP. They will be serving for routing between other branches and the ISP and bandwidth management. I am trying to differentiate between the plethora of information about having redundant, automatic failover routers and p...

...running under dd-wrt. My question is - which makes it a tiny bit CentOS-related - does anyone with such a router know of a way to wake the router up in such a case through the computer? I wouldn't have dared to ask this question here or anywhere until recently, as I assumed my ancient Linksys routers were obsolete. But I've been reading posts recently saying that there hasn't really been a Linux router to replace the WRT54GL, and in particular Linksys's recent 11n replacement is not as good as the old model in many ways. Anyway, if anyone has an answer to my query I should be very...

Hi, Does anybody else have problems like this. I'm in the UK with a 1mb ADSL service from Eclipse. I have a Draytek Vigour 2600 ADSL router. My * box is configured with a public IP address which is presented on one of the switch ports on the rear of the router. When there is some SIP activity, incoming mainly, towards my * box, the router will lockup after a short period?! I've tried

Hi, I am trying to dial a registered user via his IP:Port mechanism, but problem is that the audio data is not reaching to dialed user. here is the scenario. caller and callee both are registered at asterisk server. asterisk server is on public ip so no port forwarding and natting necessary there. however caller and callee both are behind router and there is port forwarding enabled and nat=yes,

Hi all, I have a Linux box with two connections to the internet over two routers and a private internal network. The linux box does masquerading. internet +----------+ 172.16.0.1 +-------------------+ <---- | Router 1 |-------------------| | +----------+ | 172.16.0.2 | |...

...d it, it is always when Asterisk starts up. Has anyone else seen this problem? It is very odd because this is a very good router and we had the Asterisk server on an exact same router but different network before and it did not cause a crash. We have gone through two different Cisco 7200 series routers and both exhibited the same problems. Any clues? Thanks - -- -- Heritage Communications Corporation Melbourne, FL USA 32935 http://www.hcc.net

...es. So when I was doing the above from 192.168.5.27 > going through the router through Comcast is when I had the problem. > --- Try this: For the NIC on your Comcast router set its ip to one that the dhcp in the router gives out + DFG + 2 DNS entries. In order to have it static. I see lots of routers with your problem. John

Hi all, I am using a redhat 8.x linux box configured with zebra routing software which is also configured with ospfd I have 2 backbone routers running ospf connected to different isp''s I have 3 local routers also running ospf within themselfs and also with the 2 backbone routers (all are linux boxes) router A - backbone router 1 router B - backbone router 2 router C - local router 1 (has 3 subnets routed via it) router D - l...

Hello, I am trying to figure out a problem I'm having using CentOS on a machine as a router. The short story is: any traffic routed through the router seems to get disconnected at random occasionally. The hardware setup is: I have two switches, the router sits between them, the webserver on the LAN switch. The machine I'm using for the router is a Dell 860 1U rackmount with two NICs,

...e here a larger vpn (about 30 subnets) at time with OpenVPN. OpenVPN only supports PointToPoint connections so the setup is complex. Many transport Networks, many routes. The examples from your Webpage are nice, but i think a nicer way to use the strengh of tinc is: We define a Subnet where all routers are, for example: 172.120.121.0/24 With tinc its now easy to configure this on every router, so all routers are fully connected. Router A gets, 172.120.121.1 Router B gets, 172.120.121.2 Router C gets, 172.120.121.3 . . so we only have to add to every router these Adresse in its Subnet List, R...

The situation is this: INTERNET -- ROUTER -- ETHERNET+WIFI -- PC's The conection between INTERNET and ROUTER is done with 2 LINKs with static IP's. The conection between ROUTER and PC's is done via ETHERNET lan with many bridges and ACCESSPOINTS. The PC's are in a IP subnet, the BRIDGES in another IP subnet, the AP's in another IP subnet. The ROUTER has 1 bridge interface

Hi folks, I need to develop asyncronous connection just like in DVB Satellite One Way Service, in my network. Incoming traffic and Outgoing traffic flowing through different link and interface. Here i describe you more, Existing system: [ Router A ] eth0 : 192.168.0.1 | | | | eth0 : 192.168.0.2 [ Router B ] Router A and Router B on the same

On Tue, 06 Jun 2017 21:53:00 +0100 Rodolfo Medina <rodolfo.medina at gmail.com> wrote: > Rowland Penny via samba <samba at lists.samba.org> writes: > > This is with my router: > > > > rowland at devstation:~$ sudo mount.cifs //192.168.0.1/USB1 /mnt/cifs > > Password for root@//192.168.0.1/USB1: <-- I just pressed 'Enter' > > rowland at

On Tue, 06 Jun 2017 22:34:06 +0100 Rodolfo Medina <rodolfo.medina at gmail.com> wrote: > Rowland Penny via samba <samba at lists.samba.org> writes: > > > On Tue, 06 Jun 2017 21:53:00 +0100 > > Rodolfo Medina <rodolfo.medina at gmail.com> wrote: > > > >> Rowland Penny via samba <samba at lists.samba.org> writes: > >> > This is