search for: mutipath

Hi, I just deploy the ZFS on an SAN attach disk array and it''s working fine. How do i get dual pathing advantage of the disk ( like DMP in Veritas). Can someone point to correct doc and setup. Thanks in Advance. Rgds Vikash Gupta This message posted from opensolaris.org

Hi, i''m trying to do loadbalancing with a linux embedded with a MIPS procesor, but I''m in trouble. I have the kernel 2.4.20, and iproute2 ss010824. I compiled without errors, but when I executed the ip comand to install de mutipath default route I get the following error (all the previous commands have been executed according to the LARTC-HOWTO in section 4.2): linux# ip route add default scope global \ nexthop via 200.200.200.1 dev eth1 weight 1 \ nexthop via 100.100.100.1 dev eth2 weight 1 RTNETLINK answers:...

hi all, i am setting up a load balancing netwrok with failover, i have applied julian patch, but whenever i try to traceroute from any client node, it gives me two entries for that destination, but i get different interface for that entries, so it doesn''t forward my requests, i have done masquerading for client nodes, the ip rule/route are as follows, ip rule add prio 222 table

We've been wrestling with this for ... rather longer than I'd care to admit. Host / initiator systems are a number of real and virtualized CentOS 5.5 boxes. Storage arrays / targets are Dell MD3220i storage arrays. CentOS is not a Dell-supported configuration, and we've had little helpful advice from Dell. There's been some amount of FUD in that Dell don't seem to know what