search for: foken

...al keyboard and use only the RS232 interface. "console 0" suppresses only writing to the graphics card, but it does not disable reading the local keyboard. Perhaps there is a way to (ab-)use the keymap feature, mapping all keys to "no key pressed"? Alexander -- Alexander Foken mailto:alexander at foken.de http://www.foken.de/alexander/

On Sat, Sep 22, 2012 at 08:31:51AM +0200, Bernd Blaauw wrote: > Op 22-9-2012 0:58, H. Peter Anvin schreef: > > > MEMDISK doesn't load anything. Syslinux loads things, and uses a block > > size of (typically) 63.5K which is the maximum supported by EDD 3.0. > > Thank you very much for stating this performance limitation to > syslinux core, and likely linux.c32

Hello, I noticed the following behavior of extlinux 4.05: I created an ext3 filesystem on the first (primary and active) partition of a usb stick. I mounted it at /mnt/. Then I copied to /mnt/ldlinux.sys the ldlinux.sys found in the syslinux 4.05 archive and I created a basic /mnt/extlinux.cfg. Then I ran "extlinux -i /mnt/" and rebooted on the usb stick. I got "ERROR: No

Hi All, I have a system, that, ~80% of the time, fails to properly boot using pxelinux.0 as provided by RHEL 5.5 (syslinux 3.11, I think). The gripe, before the console messages stop, is a message that comes from the linux kernel complaining the compressed ram drive image is bad: "invalid compressed format (err=[small number])". I have two questions: 1. How should I go about