Displaying 7 results from an estimated 7 matches for "columbiacomput".
2007 Jan 18
5
1 phone 2 voicemail accounts
What is the best way to have 1 phone check multiple voicemail accounts. I am using polycom 650 phones, and am wondering if mwi can work when checking multiple accounts.
-Chris
Sent from my BlackBerry? wireless handheld
2006 Dec 13
1
CallerID Issue (asterisk newbie)
Hi guys. This is my 1st post here (after much reading). I have a test
asterisk system setup using X-Lite Soft Phones, and the issue I am
running into is that caller id shows up as "asterisk" on all incoming
calls and on all local to local calls (internal). I have showcallerid,
etc. configured in zapata.conf, but I'm drawing a blank. When I check
my voicemails it tells me
2007 Jan 10
1
Zap 1.4 error line 0: Unable to open
Here is the complete output of ztcfg:
Notice: Configuration file is /etc/zaptel.conf
line 0: Unable to open master device '/dev/zap/ctl'
1 error(s) detected
It appears that none of the zaptel devices have been created. I did not
notice any errors during the make install. Does anyone have any
suggestions? I know the hardware works, because it was working as my
asterisk 1.2 test
2007 Jan 10
0
app_system.c:105 system_exec_helper: Unable to execute '/sbin/zapscan.bin'
When I load the asterisk 1.4 gui and log into
"/asterisk/static/config/setup/install.html", it tells me "No Analog ports
has been detected on your system".
I have 2 Wildcard X100P cards that are properly installed. Ztcfg shows no
problems.
I also get the following message from the asterisk console "
app_system.c:105 system_exec_helper: Unable to execute
2007 Jan 12
2
SLA
Hi. I've been researching very deep into SLA in Asterisk 1.4, and am unclear
as to if the feature exist. I know the commands and configs are available,
but there is no documentation, and I've heard that it will not be supported
until 1.4.1. Does anyone have a definitive answer on this?
If it is available, is there any documentation on the feature?
-Chris
2007 Jan 23
2
Asterisk 1.4 & Polycom buddy status
I'm running into an issue w/ Buddy status on Polycom IP650 phones using
buddy status (with SIP Hints) on Asterisk 1.4. Sometimes the status on the
phones will "stick" in the busy status. I have noticed that I can call that
extension & the status will reset (sometimes). Anyone else encountered this
or anything similar.
-Chris
2007 Jan 09
3
Zap 1.4 error line 0: Unable to open master device '/dev/zap/ctl'
I've looked over EVERY resource I can find, but have run short of a
solution. I'm running CentOS 4.4. Just installed Asterisk 1.4 and Zaptel
1.4 and libpri, but when I run ztcfg I get this error: line 0: Unable to
open master device '/dev/zap/ctl'
I realize this is a udev error (or from what I've read), but I cannot find
out how to resolve this. I've reinstalled zaptel