search for: balagop

...imes a samba print job goes to the wrong printer. Normally everything works just fine. Shown below is the lprng acct log file enries for the concerned print job. Please notice that the print job was supposed to go to hp4050-mail, but ended up in hp8100. Any suggestions are much appreciated. Thanks Balagopal jobstart '-Hgate24a.MathStat.Dal.Ca' '-nsarah' '-Php8100' '-kcfA622gate24a.MathStat.Dal.Ca' '-b177794' '-t2003-05-08-12:27:45.000' '-CA' '-Jmccurdy@medway.MathStat.Dal.Ca,-h,-Php4050-mail,smbprn.000523.kVBZ5m' jobend '-Hgate24...

...these error messages is much appreciated. The two lustre oss/mds/mgs servers have been running fine with an uptime for over a month now after the ldiskfs patch is applied as mentioned here - https://bugzilla.lustre.org/show_bug.cgi?id=13438 The version of Lustre is 1.6.3. Thanks Balagopal

...f a tar file, bonnie etc etc) I also tested the same thing on the nfs exported backup volume of the filled up lustre volume (exported from the same OSS server) and it doesn''t show any significant slow down. Is it normal for Lustre volumes to slow down when the volumes get full? Thanks Balagopal

Hi, we would like to establish a small Lustre instance and for the OST planning to use standard Dell PE1950 servers (2x QuadCore + 16 GB Ram) and for the disk a JBOD (MD1000) steered by the PE1950 internal Raid controller (Raid-6). Any experience (good or bad) with such a config ? thanxs, Martin

Hi, Lustre manual 1.6 v18 says that that in production lustre debug level should be set to fairly low. Manual also says that I can verify that level by running following commands: # sysctl portals.debug This gives ne following error error: ''portals.debug'' is an unknown key cat /proc/sys/lnet/debug gives output: ioctl neterror warning error emerg ha config console cat