Hello, I found out that installing a new version of Samba isn't just entering the command make install (after configure and make of course) I had a lot of trouble when I installed samba version 3.0.1 pre2, Windows 98 client didn't do logon's anymore. When I switched back to samba 3.0.0 rc1, no problems. I spent a lot of time finding out what was wrong. I did not see any message in the mailinglist about "not able to logon with version 3.0.1pre2", so it had to be my installation. After a long time I found out that I had to clean the "lock" directorie: remove all tdb files. After I did that everything was ok again. Now, I think it's good to know for everybody! After installation of a new version, remove all "tdb" and "dat" files, and start from scratch. Or am I the only person who did not know this? That would be really a waste of time. Stef And by the way: samba team, keep up the good work.