Hi, i have the ups in the subject. It is connected with usb cable. With nut 2.4.3 it was working quite good with megatec-usb driver. Now i just upgraded to nut 2.6 on my gentoo system and switching to blazer_usb is not working. Copying old megatec_usb driver from 2.4.6 and using it, everything returns to function. Some output with blazer_usb: ?* Service upsdrv starting Network UPS Tools - UPS driver controller 2.6.0 Network UPS Tools - Megatec/Q1 protocol USB driver 0.03 (2.6.0) No supported UPS detected Driver failed to start (exit status=1) ?Failed to start UPS drivers! ???????????????????????????????????????????????????????????????????? [ !! ] ?* ERROR:? upsdrv failed to start with megatec_usb: ?* Service upsdrv starting Network UPS Tools - UPS driver controller 2.6.0 Network UPS Tools - Megatec protocol driver 1.6 (2.4.3) Serial-over-USB transport layer 0.10 Megatec protocol UPS detected [? VT12094S]. ?* Service upsdrv started What can I do to use the new, still supported and developed blazer driver? Many thanks Andrea
Citeren Andrea <krog.az op gmail.com>:> Some output with blazer_usb: > > ?* Service upsdrv starting > Network UPS Tools - UPS driver controller 2.6.0 > Network UPS Tools - Megatec/Q1 protocol USB driver 0.03 (2.6.0) > No supported UPS detected > Driver failed to start (exit status=1) > ?Failed to start UPS drivers! > ???????????????????????????????????????????????????????????????????? [ > !! ] > ?* ERROR:? upsdrv failed to startStart the driver again, now with debugging enabled: /path/to/blazer_usb -DDD -a <upsname> Assuming the detection will fail, just post the full output from the above command here. Just to be sure, post the output of lsusb -v as well. Best regards, Arjen -- Please keep list traffic on the list (off-list replies will be rejected)