Josef Kulhánek
2020-Jun-19 10:53 UTC
[Nut-upsdev] HCL <FSP> <Champ Tower 1k> supported by <blazer_usb>
Hi everybody, following UPS is successfuly tested. Model: FSP Champ Tower 1k https://www.fsp-europe.com/CS/champ-tower-series-1k2k3k/ lsusb: Bus 002 Device 004: ID 0665:5161 Cypress Semiconductor USB to Serial ups.conf: [powerpal] driver = blazer_usb port = /dev/hidraw0 Mode = standalone Distro = CentOS 8 What I did to get UPS communicate. In terminal run as root: ln -s /lib/udev/rules.d/62-nut-usbups.rules /etc/udev/rules.d/ udevadm control --reload-rules udevadm trigger output upsc: Init SSL without certificate database battery.charge: 100 battery.voltage: 27.24 battery.voltage.high: 26.00 battery.voltage.low: 20.80 battery.voltage.nominal: 24.0 device.mfr: device.model: WPHVT1K0 device.type: ups driver.name: blazer_usb driver.parameter.pollinterval: 2 driver.parameter.port: /dev/hidraw0 driver.parameter.synchronous: no driver.version: 2.7.4 driver.version.internal: 0.12 input.current.nominal: 4.0 input.frequency: 50.0 input.frequency.nominal: 50 input.voltage: 232.9 input.voltage.fault: 232.9 input.voltage.nominal: 230 output.voltage: 229.7 ups.beeper.status: enabled ups.delay.shutdown: 30 ups.delay.start: 180 ups.firmware: 01060.04 ups.load: 20 ups.mfr: ups.model: WPHVT1K0 ups.productid: 5161 ups.status: OL ups.temperature: 27.0 ups.type: online ups.vendorid: 0665 output upscmd -l: Instant commands supported on UPS [powerpal]: beeper.toggle - Toggle the UPS beeper load.off - Turn off the load immediately load.on - Turn on the load immediately shutdown.return - Turn off the load and return when power is back shutdown.stayoff - Turn off the load and remain off shutdown.stop - Stop a shutdown in progress test.battery.start - Start a battery test test.battery.start.deep - Start a deep battery test test.battery.start.quick - Start a quick battery test test.battery.stop - Stop the battery test Regards PepaK -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://alioth-lists.debian.net/pipermail/nut-upsdev/attachments/20200619/78c37908/attachment.html>
Seemingly Similar Threads
- fentonups driver patch for Effekta MHD3000 UPS
- Fw: RESTORATION of POWER .... I seem to have cabling & drivers set up correctly for a contact closure UPS BUT ..........
- Fenton PowerPal 660 strange reading and issues...
- NUT driver for fenton powerpal S1500
- Fenton Powerpal L1400R "Not Supported" message...