Hello,
I'm new to the list, new to NUT, but not new to Unix-likes. I
could use some help getting NUT to talk to my Tripp Lite G1000U.
Searching Google for "Tripp Lite G1000U" returns exactly two hits
at this writing, so that may not be a good sign. ;-) It may just
be rebranded for sale through this source (Costco).
Externally, the G1000U looks much like the SMART1000LCD: an amber
LCD, jacks for coax and telephone, four protected receptacles and
four non-protected, and a USB-only interface. Internally, it's
product 2007, vendor 09ae.
I am running FreeBSD 6.4 with a stock kernel (and so uhid is
enabled) and I installed the FreeBSD port of NUT (nut-2.2.2) today
with the following options set:
[ ] SERIAL SERIAL support
[X] USB USB support
[X] SNMP SNMP support
[X] NEON NEON XML/HTTP support
[ ] HAL HAL support
[X] IPV6 IPV6 support
[ ] DEVEL Install header files
[X] CGI Web CGI interface
I read Charles Sprickman's helpful post 'Some FreeBSD tips':
http://lists.alioth.debian.org/pipermail/nut-upsuser/2007-March/002513.html
... but I wasn't able to figure out if uhid should be disabled or not
for my unit. I am in the process of compiling a kernel without uhid
so that I can try the tripplite_usb driver, but I wanted to also post
here because of the lack of G1000U information indexed by Google.
Here's how I tried the driver:
$ sudo /usr/local/libexec/nut/usbhid-ups -a tripplite-g1000u -u root -DDD
Network UPS Tools: 0.29 USB communication driver - core 0.33 (2.2.2)
debug level is '3'
upsdrv_initups...
No appropriate HID device found
No matching HID UPS found
Other information as follows:
Kernel message on attachment:
kernel: uhid0: Tripp Lite TRIPP LITE UPS, rev 1.10/0.10, addr 2, iclass 3/0
$ sudo usbdevs -d -v
Controller /dev/usb0:
addr 1: full speed, self powered, config 1, UHCI root hub(0x0000),
VIA(0x0000), rev 1.00
uhub0
port 1 addr 2: low speed, power 100 mA, config 1, TRIPP LITE
UPS(0x2007), Tripp Lite(0x09ae), rev 0.10
uhid0
[snip]
$ nocomment ups.conf
[tripplite-g1000u]
driver = usbhid-ups
port = auto
desc = "primary UPS"
$ nocomment upsd.conf
ACL all 0.0.0.0/0
ACL localhost 127.0.0.1/32
ACL lan [redacted]
ACCEPT localhost lan
REJECT all
Any help appreciated, especially if I'm missing something obvious in
the configs. If the G1000U is new to the project, I'm more than
willing to play guinea pig.
And thanks for the project generally - I was pleased to find something
this sophisticated, and hope to give back in some way.
Royce