Hello, I have a weird issue using a BCM95721 in bridged mode. In a production server I have eth0: Tigon3 [partno(BCM95721) rev 4201] (PCI Express), which is part of a bridge, with some tap interfaces on which some virtual machines reside. Everything works like a charm. This server runs Debian squeeze, 2.6.32-5-amd64 kernel. On a testing server I have eth0: Tigon3 [partno(BCM95721) rev 4101] (PCI Express) (older revision, same hardware?). Here, the card will not work properly in briding mode: it does not 'see' packets not destined for its own MAC address. Even running a tcpdump in promiscous mode does not show these packets. Running it non-bridged works fine. The result is that, if the bridge MAC is different from the eth0 MAC, the host is not reachable. If the bridge MAC happens to be the same as the eth0 MAC, the host itself is reachable, but bridging obviously still doesn't work. I tested the testing server using the same 2.6.32-5-amd64 kernel as the production machine uses (including firmware), and to my surprise that kernel also doesn't work. So apparently rev 4101 contains some kind of bug wrt bridging mode. It almost seems like promiscous mode is reset somehow, kind of like the (very old) problem described here: http://www.spinics.net/lists/linux-ethernet-bridging/msg00756.html This is on a very old version however, I could not reuse those steps in debugging this issue on my kernel version. To rule out hardware issues, I have another identical machine (hw and sw) with the same issue. Also, plugging in an intel card which I happened to have lying around works just fine... Does anyone have any ideas on how to test/debug/fix this issue? Michel.