Thanks. The example on the filter section has nothing to do with the
example of PRIO used earlier.
On Tue, 2 Nov 2004 10:27:53 -0800, Orlie Brewer
<orlie.t.brewer@boeing.com> wrote:> Hello,
>
> The parent of a filter should be the handle of the qdisc containing the
> classes to which you are trying to route the packets, in this case, the
prio
> qdisc 1: The flowid should be the handle of the class to which you want
the
> packets forwarded, in this case 1:1. When you forward packets to a class,
> they will be queued in the qdisc attached to the class, in this case, the
sfq
> qdisc 10:
>
> So the filter command should read
>
> > tc filter add dev eth0 parent 1: protocol ip prio 1 u32 match ip dport
> > 22 0xffff flowid 1:1
>
> Hope this helps.
>
> Orlie
>
>
>
> On Monday 2004.11.01 18:38, Mario Bittencourt wrote:
> > Hi,
> >
> > I''ve read the lartc doc but got stuck :)
> >
> > I''ve created a prio qdisc (the example)
> >
> > tc qdisc add dev eth0 root handle 1: prio
> > tc qdisc add dev eth0 parent 1:1 handle 10: sfq
> > tc qdisc add dev eth0 parent 1:2 handle 20: tbf rate 20kbit buffer
> > 1600 limit 3000
> > tc qdisc add devl eth0 parent 1:3 handlle 30: sfq
> >
> > Then I tried to create filters to make priority traffic go to the
first band
> >
> > tc filter add dev eth0 parent 10: protocol ip prio 1 u32 match ip
> > dport 22 0xffff flowid 10:1
> >
> > The command above does not work. If I change
> >
> > tc filter add dev eth0 parent 1: protocol ip prio 1 u32 match ip dport
> > 22 0xffff flowid 10:1
> >
> > It goes ok.
> >
> > So, is this a typo or something is wrong ?
> >
> > How about the flowid ? Is it the handle of the qdisc I should
> > "forward" the packet to ?
> > _______________________________________________
> > LARTC mailing list / LARTC@mailman.ds9a.nl
> > http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
> >
>
_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/