On Sunday 22 December 2002 03:37, Hannes Ebner wrote:> hi devik,
>
> i have found the following you have written some time ago:
> > It is important to know that for precise operation quantums need to
> > be as small as possible and larger than MTU. Normaly you
don''t need
> > to specify quantums manualy as HTB chooses precomputed values. It
> > computes classe''s quantum (when you add or change it) as its
rate
> > divided by r2q global parameter. Its default value is 10 and because
> > typical MTU is 1500 the default is good for rates from 15 kBps (120
> > kbit). For smaller minimal rates specify r2q 1 when creating qdisc -
> > it is good from 12 kbit which should be enough. If you will need you
> > can specify quantum manualy when adding or changing the class.
>
> what would be the best solution for rates smaller than 120kbit? i
don''t
> know how the higher rates are affected by scaling r2q down to 1, but
> would this be a solution for rates from 12kbit?
>
> would it be better to calculate the quantum for each rate or to set a
> small quantum for all rates?
The best you can do is following this rules and choose a good r2q :
- 1500 < rate_small / r2q
- rate_bigg / r2q < 60.000
with
- rate_small = smallest rate
- rate_bigg = biggest rate
Quantum is only used if you have 2 or more class fighting for remaining
bandwidth from the same parent. And with remaining, I mean that each class
already received it''s rate and that the parent has some bandwidth left.
Stef
--
stef.coene@docum.org
"Using Linux as bandwidth manager"
http://www.docum.org/
#lartc @ irc.oftc.net
_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/