Hi, How can I load the alpm(4) module for SMBus support on my ASUS Vintage AH-1 system? It appears the I/O range it uses is claimed by the acpi(4) driver. Can I override the mapping in some way i.e. tell ACPI not to claim the range? I don't see anything obvious about this in the acpi(4) man page. thanks, BMS
On Thu, Sep 11, 2008 at 11:44:20AM +0100, Bruce M Simpson wrote:> How can I load the alpm(4) module for SMBus support on my ASUS Vintage > AH-1 system? > > It appears the I/O range it uses is claimed by the acpi(4) driver. Can I > override the mapping in some way i.e. tell ACPI not to claim the range? > I don't see anything obvious about this in the acpi(4) man page.Might mention this to jhb@ to see if it's related to the SMBus changes made 1.5 years ago: http://www.freebsd.org/cgi/cvsweb.cgi/src/sys/pci/alpm.c I found this thread, which despite being USB-centric, shows someone trying to load alpm(4) on RELENG_6 and getting a map allocation error back in 2003. Not sure if this is of any help: http://lists.freebsd.org/pipermail/freebsd-mobile/2003-April/000190.html http://lists.freebsd.org/pipermail/freebsd-mobile/2003-April/000192.html -- | Jeremy Chadwick jdc at parodius.com | | Parodius Networking http://www.parodius.com/ | | UNIX Systems Administrator Mountain View, CA, USA | | Making life hard for others since 1977. PGP: 4BD6C0CB |
Hello. I have same error message on Sharp PC-CV50. 
Is it a hardware or BIOS problem ?
  The device dosen't have PCIM_CMD_PORTEN bit on PCIR_COMMAND
(address 0x04, bit 0), and dosen't have any valid address on PCIR_BAR(x).
pciconf can't write PCIR_BAR(x).
`pciconf -lv` shows:
none0@pci0:3:1:	class=0x068000 card=0x104313bd chip=0x710110b9 rev=0x00 hdr=0x00
    vendor     = 'Acer Labs Incorporated (ALi/ULi)'
    device     = 'ALI M7101 Power Management Controller'
    class      = bridge
and `pciconf -r pci0:3:1 0:0x1f` shows:
710110b9 02000000 06800000 00800000
00000000 00000000 00000000 00000000 
-- 
KAHO Toshikazu
Maybe Matching Threads
- [Bug 109558] New: Plasma locks up after splash screen
- dovecot: config: Error: BUG: Config client connection sent too much data
- CentOS 5.4 Network install
- dovecot: config: Error: BUG: Config client connection sent too much data
- [pv_ops] e1000e: "Detected Tx Unit Hang"