freebsd stable - Feb 2006 - FreeBSD6 on PowerEdge 4200

Hello, i'm trying to install FreeBSD6 on an old PowerEdge 4200. But i cannot
even get to sysinstall, when it's booting from the cd it gets to a point 
where the system reboots, these are the messages i can see on the console:

...
amr0: <LSILogic MegaRAID 1.51> port 0xf480-0xf4ff irq 9 at device 19.0 on
pci0
amr0: busmaster bit not set, enabling
amr0: polled command timeout
amr0: polled command timeout
panic: amr: slot 0 busy?

Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort
...

It happens with FreeBSD5.4 and FreeBSD6.0 install disks, but not with a 
FreeBSD4.10 disc, any clue on what could be happening?

Thanks a lot

On Thu, 2 Feb 2006, Enrique Ayesta Perojo wrote:
> Hello, i'm trying to install FreeBSD6 on an old PowerEdge 4200. But i
cannot
> even get to sysinstall, when it's booting from the cd it gets to a
point
> where the system reboots, these are the messages i can see on the console:
>
> ...
> amr0: <LSILogic MegaRAID 1.51> port 0xf480-0xf4ff irq 9 at device
19.0 on pci0
> amr0: busmaster bit not set, enabling
Try updating the system BIOS and the PERC card's firmware to the latest,
and make sure the card is enabled in the BIOS (if its onboard).
This indicates the device isn't being configured properly by the BIOS.

-- 
Doug White                    |  FreeBSD: The Power to Serve
dwhite@gumbysoft.com          |  www.FreeBSD.org