Hello, I am trying to run Dovecot with IPv6 and IPv4. I have the following command in my conf: listen = * This makes Dovecot listen on all addresses on IPv4. I then add: listen = [::] So the conf now has both listen lines. This forces Dovecot to listen on all IPv6 addresses, but it no longer responds to requests on IPv4. Is there a way to get Dovecot to listen on both protocols? -- Steve King Senior Linux Engineer - Advance Internet, Inc. Cisco Certified Network Associate CompTIA Linux+ Certified Professional CompTIA A+ Certified Professional
On Jul 3, 2010, at 10:24, Steven King wrote:> Hello, > > I am trying to run Dovecot with IPv6 and IPv4. I have the following > command in my conf: > > listen = * > > This makes Dovecot listen on all addresses on IPv4. > I then add: > > listen = [::] > > So the conf now has both listen lines. This forces Dovecot to listen on > all IPv6 addresses, but it no longer responds to requests on IPv4. > > Is there a way to get Dovecot to listen on both protocols?listen = *, [::]> -- > Steve King > > Senior Linux Engineer - Advance Internet, Inc. > Cisco Certified Network Associate > CompTIA Linux+ Certified Professional > CompTIA A+ Certified Professional >
On Sat, 3 Jul 2010, Steven King wrote:> I am trying to run Dovecot with IPv6 and IPv4. I have the following > command in my conf: > > listen = * > > This makes Dovecot listen on all addresses on IPv4. > I then add: > > listen = [::] > > So the conf now has both listen lines. This forces Dovecot to listen on > all IPv6 addresses, but it no longer responds to requests on IPv4. > > Is there a way to get Dovecot to listen on both protocols?listen = *, [::] But that may be the default anyway so if you leave it commented out I think you get the same effect. Antonio Querubin 808-545-5282 x3003 e-mail/xmpp: tony at lava.net