Hi What should be the optimal settings for HWEC related parameters in wanpipe1.conf to be able to receive Fax over T.30 on a Sangoma A108DE Card ? In particular, should I enable echo ? If yes, to what parameter ? What other values like RXGAIN, TXGAIN should I tune ? TDMV_HW_DTMF = YES # YES: receive dtmf events from hardware TDMV_HW_FAX_DETECT = YES # YES: receive fax 1100hz events from hardware HWEC_OPERATION_MODE = OCT_NORMAL # OCT_NORMAL: echo cancelation enabled with nlp (default) # OCT_SPEECH: improves software tone detection by disabling NLP (echo possible) # OCT_NO_ECHO:disables echo cancelation but allows VQE/tone functions. HWEC_DTMF_REMOVAL = NO # NO: default YES: remove dtmf out of incoming media (must have hwdtmf enabled) HWEC_NOISE_REDUCTION = NO # NO: default YES: reduces noise on the line - could break fax HWEC_ACUSTIC_ECHO = NO # NO: default YES: enables acustic echo cancelation HWEC_NLP_DISABLE = NO # NO: default YES: guarantees software tone detection (possible echo) HWEC_TX_AUTO_GAIN = 0 # 0: disable -40-0: default tx audio level to be maintained (-20 default) HWEC_RX_AUTO_GAIN = 0 # 0: disable -40-0: default tx audio level to be maintained (-20 default) HWEC_TX_GAIN = 0 # 0: disable -24-24: db values to be applied to tx signal HWEC_RX_GAIN = 0 # 0: disable -24-24: db values to be applied to tx signal regards, Anita -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.digium.com/pipermail/asterisk-users/attachments/20120327/5fd79126/attachment-0001.htm>