asterisk users - Oct 2010 - Echo on PRI after upgrading to Asterisk 1.6.2 from 1.2

I've recently upgraded an Asterisk system from 1.2 to 1.6.2 (did a
full reformat and recompile) and I started getting echo over the PRI.

I've tried the default settings for echo in the system.conf file as
well as I've compiled OSLEC to try and see if thats any better.

I'm not sure what to try next. Does anyone have any suggestions?

On 10/15/2010 08:55 AM, Jared Geiger wrote:
> I've recently upgraded an Asterisk system from 1.2 to 1.6.2 (did a
> full reformat and recompile) and I started getting echo over the PRI.
> 
> I've tried the default settings for echo in the system.conf file as
> well as I've compiled OSLEC to try and see if thats any better.
> 
> I'm not sure what to try next. Does anyone have any suggestions?
> 
What are the outputs of the following commands when your system is up
and running?

#] cat /etc/dahdi/system.conf
#] grep -E "^echo" /etc/asterisk/chan_dahdi.conf
#] dahdi_scan
#] lsmod | grep dahdi

-- 
Shaun Ruffell
Digium, Inc. | Linux Kernel Developer
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
Check us out at: www.digium.com & www.asterisk.org

On Fri, Oct 15, 2010 at 9:55 AM, Jared Geiger <compuwizz at gmail.com>
wrote:
> I've recently upgraded an Asterisk system from 1.2 to 1.6.2 (did a
> full reformat and recompile) and I started getting echo over the PRI.
>
I did an update on a server last year, had the same problem.  I needed
to explicitly set echocancel=yes in my configs, before 1.6 it was
enabled by default.

-- 
Paul Belanger | dCAP
Polybeacon | Consultant
Jabber: paul.belanger at polybeacon.com | IRC: pabelanger (Freenode)
blog.polybeacon.com