Hi list! I was using bristuff-0.3.0-PRE-1s with florz patch but where normally the TEI check request message were I was getting errors. Concerned about that I switched to plain vanilla bristuff. Now everything *seems* to be working without errors but I regulary get reports from people trying to call me that they get a signal that the number is not in use or is disconnected. Is anyone else experiencing the same? I'm running bristuff-0.3.0-PRE-1s on Centos 4.4 x86_64 with kernel 2.6.9-42.0.2.EL I tried setting acpi=off but then the box fails to boot and barfs up a kernel panic. Thanks for any hints / tips!
On Mon, 2006-09-11 at 21:14 +0200, Remco Barendse wrote:> Hi list! > > I was using bristuff-0.3.0-PRE-1s with florz patch but where normally the > TEI check request message were I was getting errors. > > Concerned about that I switched to plain vanilla bristuff. > > Now everything *seems* to be working without errors but I regulary get > reports from people trying to call me that they get a signal that the > number is not in use or is disconnected. > > Is anyone else experiencing the same? >yep I had the same here with BRIstuffed-0.3.0-PRE-1l it seems to get progressively worse over time. Conrad