Jorge Cisneros
2005-Oct-24 13:34 UTC
[Asterisk-Users] Ticking sound in wildcard tdm400p, Please Help
Hi
My wildcards TDM 400P's with 8 FXO port(connexts to pstn ) has ticking
noise.
I have followed http://www.voip-info.org/wiki-Asterisk+Hardware .
and make sure wctdm is not shareing interrupt with any other devices.
The sever hard disk is a scsi, so i can't run " /sbin/hdparm -u1
/dev/hda1" to avoid harddisk interference.
But the ticking is still there, what could cause the problem?
Some Information
# cat /proc/interrupts
CPU0 CPU1
0: 368078 0 IO-APIC-edge timer
1: 1358 0 IO-APIC-edge i8042
9: 0 0 IO-APIC-level acpi
16: 86018 0 IO-APIC-level eth0
17: 5308 0 IO-APIC-level aic79xx
18: 1441668 0 IO-APIC-level wctdm
19: 1440376 0 IO-APIC-level wctdm
NMI: 0 0
LOC: 368016 368017
ERR: 0
MIS: 0
Server IBM XSeries 206 PIV
lspci -vb
0000:00:00.0 Host bridge: Intel Corporation 82875P/E7210 Memory
Controller Hub (rev 02)
Subsystem: IBM: Unknown device 02ae
Flags: bus master, fast devsel, latency 0
Memory at d2000000 (32-bit, prefetchable)
Capabilities: [e4] #09 [3106]
0000:00:03.0 PCI bridge: Intel Corporation 82875P/E7210 Processor to
PCI to CSA Bridge (rev 02) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, fast devsel, latency 48
Bus: primary=00, secondary=02, subordinate=02, sec-latency=0
I/O behind bridge: 00002000-00002fff
Memory behind bridge: d0000000-d00fffff
Prefetchable memory behind bridge: 20000000-200fffff
0000:00:1c.0 PCI bridge: Intel Corporation 6300ESB 64-bit PCI-X Bridge
(rev 02) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, fast devsel, latency 48
Bus: primary=00, secondary=03, subordinate=03, sec-latency=64
I/O behind bridge: 00003000-00003fff
Memory behind bridge: d0100000-d01fffff
Prefetchable memory behind bridge: 0000000020100000-0000000020100000
Capabilities: [50] PCI-X bridge device.
0000:00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev 0a)
(prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=04, subordinate=04, sec-latency=32
Memory behind bridge: d0200000-d02fffff
Prefetchable memory behind bridge: e0000000-efffffff
0000:00:1f.0 ISA bridge: Intel Corporation 6300ESB LPC Interface
Controller (rev 02)
Flags: bus master, medium devsel, latency 0
0000:00:1f.3 SMBus: Intel Corporation 6300ESB SMBus Controller (rev 02)
Subsystem: IBM: Unknown device 02ad
Flags: medium devsel, IRQ 5
I/O ports at 1400
0000:02:01.0 Ethernet controller: Intel Corporation 82547GI Gigabit
Ethernet Controller
Subsystem: IBM: Unknown device 02ad
Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 11
Memory at d0020000 (32-bit, non-prefetchable)
Memory at d0000000 (32-bit, non-prefetchable)
I/O ports at 2000
Capabilities: [dc] Power Management version 2
0000:03:04.0 SCSI storage controller: Adaptec AIC-7901 U320 (rev 10)
Subsystem: Adaptec: Unknown device 005f
Flags: bus master, 66Mhz, slow devsel, latency 72, IRQ 7
I/O ports at 3400 [disabled]
Memory at 00000000d0100000 (64-bit, non-prefetchable)
I/O ports at 3000 [disabled]
Capabilities: [dc] Power Management version 2
Capabilities: [a0] Message Signalled Interrupts: 64bit+
Queue=0/1 Enable-
Capabilities: [94] PCI-X non-bridge device.
0000:04:02.0 VGA compatible controller: ATI Technologies Inc Radeon
RV100 QY [Radeon 7000/VE] (prog-if 00 [VGA])
Subsystem: IBM: Unknown device 02c8
Flags: bus master, stepping, medium devsel, latency 66, IRQ 3
Memory at e0000000 (32-bit, prefetchable)
I/O ports at 4000
Memory at d0200000 (32-bit, non-prefetchable)
Capabilities: [50] Power Management version 2
0000:04:06.0 Communication controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
Subsystem: Unknown device b119:0003
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at 4400
Memory at d0210000 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 2
0000:04:08.0 Communication controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
Subsystem: Unknown device b119:0003
Flags: bus master, medium devsel, latency 32, IRQ 4
I/O ports at 4800
Memory at d0211000 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 2
cat /etc/zaptel.conf
fxsks=1-8
defaultzone=us
loadzone=us
cat /etc/asterisk/zapata.conf
;
; Zapata telephony interface
;
; Configuration file
[trunkgroups]
[channels]
signalling=fxs_ks
echocancel=yes
echocancelwhenbridged=no
echotraining=800
callerid=asreceived
group=0
context=from-pstn
language=es
faxdetect=incoming
busydetect=yes
busycount=4
channel => 1-8
The syslog
Oct 24 14:57:28 tux kernel: Zapata Telephony Interface Registered on major 196
Oct 24 14:57:28 tux kernel: ACPI: PCI Interrupt 0000:04:06.0[A] -> GSI
17 (level, low) -> IRQ 18
Oct 24 14:57:28 tux kernel: Freshmaker version: 73
Oct 24 14:57:28 tux kernel: Freshmaker passed register test
Oct 24 14:57:28 tux kernel: Module 0: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Module 1: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Module 2: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Module 3: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Found a Wildcard TDM: Wildcard TDM400P REV
I (4 modules)
Oct 24 14:57:28 tux kernel: ACPI: PCI Interrupt 0000:04:08.0[A] -> GSI
21 (level, low) -> IRQ 19
Oct 24 14:57:28 tux kernel: Freshmaker version: 73
Oct 24 14:57:28 tux kernel: Freshmaker passed register test
Oct 24 14:57:28 tux kernel: Module 0: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Module 1: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Module 2: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Module 3: Installed -- AUTO FXO (FCC mode)
Oct 24 14:57:28 tux kernel: Found a Wildcard TDM: Wildcard TDM400P REV
I (4 modules)
Oct 24 14:58:00 tux kernel: Registered tone zone
Any idea?
I am so frustrated, please help.
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20051024/44f6aac8/attachment.htm
Andrew Kohlsmith
2005-Oct-24 13:40 UTC
[Asterisk-Users] Ticking sound in wildcard tdm400p, Please Help
On Monday 24 October 2005 16:34, Jorge Cisneros wrote:> My wildcards TDM 400P's with 8 FXO port(connexts to pstn ) has ticking > noise.No interrupt sharing, good... you're using IOAPIC which should work just fine... there's nothing obvious at this point that I've seen. Try booting without the IO APIC (pass the kernel parameter "noapic") and see if that helps. You may also want to remove one of hte cards and see if the clicking goes away. And finally -- these are Digium cards. Have you called Digium technical support? You've paid for their support in the price of the cards, and they are the best ones to help you with this problem. -A.