Hi, I tried to connect cisco 7910 into asterisk system using chan_sccp.so. But I got a major issue : - when I called from 7910 to another sip phone in the same asterisk server, the call took place normally. - when I called from 7910 to another sip phone in different asterisk server, the call is answered but I cannot hear nor say anything. The phone just immediately lose its tone. - when I got a call from another sip phone in the same asterisk server, the phone rang. But after I picked the handset, there were no tone at all.. sccp debug on CLI produced the following messages: SCCP: Alarm Message: Severity: Major (7), 29: DSP Keepalive Timeout [0x5, 0xa, 0x8, 0x2](5) [21/1090360010] I've tried different versions of chan_sccp, yet the result were still the same. Is it time for me to dump this cisco phone to the garbage can ? (I hope not) Anybody had experienced similar issues? Any suggestion will be greatly appreciated.. Thanks Best Regards, Stevanus
Hi, On 9:04:57 August 19, 2005 stevanus <step-one-too@bdg.centrin.net.id> wrote:> Hi, > > I tried to connect cisco 7910 into asterisk system using > chan_sccp.so. But I got a major issue : > > I've tried different versions of chan_sccp, yet the result were still > the same.Which version of chan_sccp did you use? Sourceforge or Berlios? There is a new fork of chan_sccp by Sergio Chersovani who started work some weeks ago and did an almost complete rewrite of the channel. This version supports a lot more features on various phones and has a lot less bugs. You could find it at chan-sccp.berlios.de (official site) or chan-sccp.org (unofficial site). There is a related mailinglist at berlios.de where Sergio does a hell of a lot of support (unless he is one vacation like at the moment :-) ) and gladly accepts bug reports :-). Regards, Stefan -- (o_ Stefan Gofferje | SCLT //\ Reg'd Linux User #247167 | VCP #2263 V_/_ Heckler & Koch - the original point and click interface