asterisk users - Mar 2005 - Re: [0] Wilcard X100P doesn't hang up when in Voicemail() and calling party hangs up.

Rich Adamson  <radamson@routers.com> wrote on 2005-03-23 09:08:
>> 
>> I have a x100p card and it doesn't detect a hangup from the calling
>> party when going in voicemail(). My PSTN provider is sending open 
>> loop disconnect (voltage decrease for a given moment of time). 
>> Actually Progress Detection is HIGHLY EXPERIMENTAL so it should not 
>> be required to fix this problem. I wonder if disconnect supervision 
>> is the same as open loop disconnection. Actually, the service is ok 
>> from my POTS provider. I did put an AbsoluteTimeout on the 
>> voicemail() but is not a viable solution as for if somebody wants to 
>> leave a 10mn message, he wont be able to do so. 
>
>You might want to look at voicemail.conf and configure the maxsilence
>for ten seconds or so.
>
>That doesn't address your disconnect supervision, but does work.

already done that and it doesn't work.

I setted it up at 8 seconds just to be sure and even 4...